- ページ 8

コンピュータ・ハードウェア Ampro ReadyPanel 6.5のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ampro ReadyPanel 6.5 20 ページ。

Chapter 1

Installing Mounting Hardware

6) Install the appropriate

mounting hardware.

Touch Screen

Air Vents

(Front)

Enclosure

Cover

75mm (2.95")

NOTE

The Mounting holes in the bottom of the ReadyPanel conform to the FDMI (Flat

Display Mounting Interface) standard for monitor mounting.

7) Locate the I/O

connectors on the front

of the ReadyPanel.

•

Install the mounting hardware for surface or wall mounting to the bottom

of the ReadyPanel. See Figure 1-2.

Note: Make sure the mounting plate clears the fan intake and

provides enough height to allow for unrestricted air flow.

Make sure not to drive the ends of the screws further than

two screw threads past the ends of the PEM nuts located on

the inside of the enclosure cover.

Refer to

Figure 1-3

connectors and controls before making connections or powering on the

ReadyPanel.

User's Guide

and

Table 1-2

for locations and descriptions of the

ReadyPanel Setup

Air Vents

(Rear)

Cooling Fan

(Bottom)

Suggested

Mounting Plate

ReadyPanel