- ページ 10

計測機器 Amprobe CO2-100のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Amprobe CO2-100 18 ページ。 Co2 meter

OPERATION

1. Press "POWER/SET" to turn instrument on and off.

At power up, it emits a short beep and performs

30 seconds countdown for meter warm up, then

enters normal mode.

2. The meter starts measurement when power

on and update readings every second. In the

condition of operating environment change (ex.

from high to low temp.), it takes 30 sec to respond

for CO2 sensor and 30 minutes for RH.

3. Press "DP/WBT" to switch temperatures

display. The lower left display will cycle from air

temperature, dew point temp., and wet bulb

temp. (Fig.1)

4. Press "HOLD" to freeze the readings, "HOLD"

icon is displayed on the left top of LCD. All current

readings are kept unchanged, except STEL and

TWA. Press "HOLD" again to cancel data hold

function.

5. Hold down "MODE/p"for more than 1 second to

activate and cancel backlight.

6. Press "MAX/MIN" to see the minimum, maximum,

and weighted average readings. Each press of it

displays MIN, MAX, STEL, TWA in sequence and

returns to normal mode. In MIN and MAX modes,

it shows the minimum and maximum readings

of CO2 on main display, and of AIR/DP/WBT

temperatures and humidity on the lower displays.

Fig.1