- ページ 12

計測機器 Amprobe CO2-100のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Amprobe CO2-100 18 ページ。 Co2 meter

Setup

The advanced setup mode lets you customize your meter.

2 types parameter are available.

P1.0: CO2 alarm threshold setting

P3.0: Temperature unit setting

P1.0 CO2 alarm threshold setting

Hold down "POWER/SET" under normal mode for more

than 1 sec to enter set up mode. To exit setup, press

"CAL/ESC" in P1.0 or P3.0.

When entering setup mode, P1.0 and "AL" are displayed

on the LCD (Fig.3). Press "ENTER" to go into P1.1 for

setting CO2 alarm threshold. The current set value will

be blinking on LCD (Fig.4). Press "p"to increase the

value or "q"to decrease. Each press tunes 100 ppm and

the alarm range is from 100 to 9900ppm. When the

preferred alarm value is set, press "ENTER" to save the

setting or "ESC" without saving and return to P1.0.

Fig.3

Fig.4

P3.0: Temperature unit setting

Press "p"or "q"in P1.0 to access P3.0 for setting up

temperature scale. Press "ENTER" and it goes into P3.1

with blinking °C or °F current set on the lower left

display. To switch °C or °F, press "p"or "q. Then press

"ENTER" to save the setting or "ESC" without saving and

return to P3.0.