- ページ 3
温度コントローラー Carbolite 201のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Carbolite 201 8 ページ。
Carbolite 201 にも： 操作説明 (4 ページ)
ページを印刷するB
O
ASIC
PERATING
2.1
Furnace or Oven Controls
Most Carbolite products are fitted with an "Instrument Switch" which cuts off power to the
controller and other parts of the control circuit. See the instruction manual for the furnace or
oven for the overall operating instructions.
To operate the 201 there must be power to the furnace or oven, and the Instrument switch must
be on. If a time switch is included in the furnace or oven circuit, this must be in an On period.
2.2
The 201 – Operation
When switched on, the controller lights up, goes through a short test routine, and then displays
the measured temperature and starts to control. The output light glows or flashes as heating
occurs.
The Page key
are hidden and cannot be accessed by the operator because they contain factory-set parameters
which should not be changed.
A single press of the page key
presses reveal the lists indicated in the Navigation Diagram in section 6.
The Scroll key
only; others may be altered by the operator. Some parameters only appear in appropriate
circumstances – for example, working setpoint does not appear if setpoint ramp rate is Off.
A single press of the scroll key
parameters in the current list indicated in the Navigation Diagram.
To return to the Home list at any time, press Page
seconds.
The Down
2.3
Basic Operation
Normally no operator action is required other than entering the setpoint, as the 201 starts to
control on being switched on, as described above.
2.4
Altering the Setpoint
With the display at "home", showing the measured temperature, press Down
display the setpoint; press again or hold down to adjust it. The display returns to the measured
temperature when no key is pressed for 0.5 seconds.
2.5
MC07
I
NSTRUCTIONS
allows access to parameter lists within the controller; most lists and parameters
displays the temperature units, normally set to °C; further
allows access to the parameters within a list. Some parameters are display-
displays the temperature units; further presses reveal the
and Up
keys are used to alter the setpoint or other parameter values.
Note: on the 201 display
the letters
like
instructions the letters are
described as m and w.
and Scroll
together, or wait for 45
201 Controller
m
w
and
look
n
u
and
. In these
or Up
once to
3