- ページ 6

温度コントローラー Carbolite 3216 P1のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Carbolite 3216 P1 20 ページ。 Type 3216

Quick Start Guide

3 Quick Start Guide

3.1

When switched on, the controller goes through a short test routine and then shows the

measured temperature (PV = Process Value) in the upper part of the display, and below it,

the set temperature (Set Point).

3.2

Press Up

or Down

temperature, the OP1 indicator will illuminate in the top left corner of the display, indicating

that the controller is calling for power (giving an output).

The controller will immediately attempt to reach the set temperature and then maintain it.

3.3

The parameters in the controller are first shown by a short code (mnemonic). After 5

Seconds a description of the parameter will scroll once along the display and then revert

back to the mnemonic. The scrolling text can be interrupted at any time by a single press of

any of the buttons, but will not scroll again until the parameter is returned to. In this manual

the mnemonic will be shown first, followed by the scrolling text in brackets;

e.g. Prog <program number>

3.4

There are two user levels in the controller; Level 1(Operator) and Level 2 (Supervisor).

Level 1 (Operator) is for the day to day operation of the controller. These parameters are

not protected by a security code.

Level 2 (Supervisor) provides access to additional parameters. Access to these is protected

by a security code

To Enter Level 2

1. Press and hold the page key

The display will show Leu 1

3. Release the page Key

4. Press the Up

5. Press the Up

If the correct code is entered, PASS should momentarily be displayed and then revert to the

level 2 home display (See Section 5.3)

If an incorrect code is entered the display reverts back to Level 1 home display (See Section

5.3)

to select the required SP. If the SP is higher than the measured

for 3 seconds.

GOTO

to choose LEu 2 (level 2)

or Down

to enter the code (Level 2 Code = 9).

MC18-GB – v1.04