- ページ 3
ガレージドアオープナー Cardale safeliftのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Cardale safelift 6 ページ。 Trackless door gear
ページを印刷する
www.thegaragedoorcentre.co.uk
1
Stand door centrally between side timbers
on packers ensuring that the bottom edge
of the Spring Mounting Brackets are set
level with the underside of the top timber.
NOTE: For fixing the spring mounting
brackets use the special GOLD coloured
screws provided. No pilot hole is needed,
just drive straight into the timber.
2
a.
Insert the gold coloured screw with
M6 washer into the slotted hole at the top
of both Spring Mounting Brackets. Do not
fully tighten at this stage (see fig. 2).
FIG 2
b.
Remove the self tapping screws
holding the door to the transit brackets.
This allows the top of the door to move
forward and the side runners to locate
fully against the side timbers.
c.
Remove remaining screw on the side
of the Transit Brackets (see fig. 2) and
discard the Transit Brackets.
3
Re-check that door is positioned centrally
between timbers and that both link arms
(see fig. 2) are equally set relative to door
panel edge (any minor adjustment will be
available on the Spring Mounting Bracket
top slotted holes) before inserting lower
gold coloured screw and M6 washer in
each side.
Tighten all four Spring Mounting
Bracket screws.
www.thegaragedoorcentre.co.uk
0800 525 442
c
b
a
4
Link arm
0800 525 442
www.thegaragedoorcentre.co.uk
Security block
FIG 3
4
On the upper fixing slot in both runners,
pilot drill 4.0 dia. × 25 deep then insert
and tighten a No. 12 × 1
Posi. screw (see fig. 2).
Fix Diecast Security Block around Spindle
at bottom of runner (ensure block does
not foul on nylon wheel) using a gold
coloured screw and M6 washer into
slotted hole. Use adjustment on slot in
block to ensure close contact with Spindle.
Once final adjustment has been made
insert and tighten the No. 10 × 1
Countersunk Posi screw into top hole on
block (see fig 3). Repeat for opposite side.
5
IMPORTANT Ensure both cables are
within side runners and correctly
engaged in grooves of pulleys and into
wheel spindle clips.
FIG 4
www.thegaragedoorcentre.co.uk
No. 10 × 1
1
/
2
C'sunk screw
Gold coloured
screw and M6
washer
1
/
" Round Head
2
1
/
"
2
Apply
spanner
here
Retaining pin
Transit screw