- ページ 2
リモコン Cardin S486 QZ2のPDF プログラミング・マニュアルをオンラインで閲覧またはダウンロードできます。Cardin S486 QZ2 2 ページ。
Cardin S486 QZ2 にも： プログラミング・マニュアル (2 ページ)
ページを印刷する
From the receiver :
1. Open the casing of your receiver. It is located next to your motor.
Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board (diagram above), press the programming button (MEMO). Keep
On the receiver circuit board (diagram above), press the programming button (MEMO). Keep
On the receiver circuit board (diagram above), press the programming button (MEMO). Keep
it pressed down. The LED light of the receiver blinks.
it pressed down. The LED light of the
3. While keeping pressed down the button MEMO, press the button you wish to program
While keeping pressed down the button MEMO, press the button you wish to program
While keeping pressed down the button MEMO, press the button you wish to program on
your new remote control until the LED light of the receiver turns off.
your new remote control until the LED light of the receiver turns off.
4. Let the buttons go.
5. The LED light of the receiver blinks.
The LED light of the receiver blinks.
6. Press the button on your n
7. The LED light of the receiver turns off.
The LED light of the receiver turns off.
8. Repeat this procedure for each button you wish to program.
Repeat this procedure for each button you wish to program.
9. Wait 10 seconds.
10. Your new remote control is programmed.
Your new remote control is programmed.
http://www.remotecontrol-express.com
Programming Manual
your new remote control again. Let it go.
express.com
- TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151
+44 (0) 207 927 3151