Cardin S486 QZ2 프로그래밍 매뉴얼 - 페이지 2
{카테고리_이름} Cardin S486 QZ2에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cardin S486 QZ2 2 페이지.
Cardin S486 QZ2에 대해서도 마찬가지입니다: 프로그래밍 매뉴얼 (2 페이지)
페이지 인쇄
From the receiver :
1. Open the casing of your receiver. It is located next to your motor.
Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board (diagram above), press the programming button (MEMO). Keep
On the receiver circuit board (diagram above), press the programming button (MEMO). Keep
On the receiver circuit board (diagram above), press the programming button (MEMO). Keep
it pressed down. The LED light of the receiver blinks.
it pressed down. The LED light of the
3. While keeping pressed down the button MEMO, press the button you wish to program
While keeping pressed down the button MEMO, press the button you wish to program
While keeping pressed down the button MEMO, press the button you wish to program on
your new remote control until the LED light of the receiver turns off.
your new remote control until the LED light of the receiver turns off.
4. Let the buttons go.
5. The LED light of the receiver blinks.
The LED light of the receiver blinks.
6. Press the button on your n
7. The LED light of the receiver turns off.
The LED light of the receiver turns off.
8. Repeat this procedure for each button you wish to program.
Repeat this procedure for each button you wish to program.
9. Wait 10 seconds.
10. Your new remote control is programmed.
Your new remote control is programmed.
http://www.remotecontrol-express.com
Programming Manual
your new remote control again. Let it go.
express.com
- TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151
+44 (0) 207 927 3151