- ページ 13

トリマー DR PRO-62VのPDF 安全・取扱説明書をオンラインで閲覧またはダウンロードできます。DR PRO-62V 20 ページ。
DR PRO-62V にも：安全・取扱説明書 (20 ページ), 安全・取扱説明書 (20 ページ)

ページを印刷する

Chapter 4: Maintaining The DR

Regular maintenance is the way to ensure the best performance and long life of your machine. Please refer to this Chapter for

maintenance intervals and procedures.

Always remove the Battery Pack before performing any maintenance or

repairs to your String Trimmer.

Changing the Cutting Line

Remove any old Line that may still be in the Spool by pushing the two Push

Tabs of the Housing in and removing the Housing (Figure17).

Note: The Spool will come off with the Housing. Ensure that the internal Spring

and Spool are in the proper orientation when reassembling.

Remove any remaining Line from the Spool.

Align the Push Tabs of the Housing with the Head and reinstall the Spool

and Housing.

Line up the notches of the Spool with the notches in the Housing

(Figure18).

Cut 16 feet of new line.

Feed one end of the new Line though one of the Eyelets until it comes out

of the Eyelet on the other side.

Continue to pull the line through until it is the same length on both sides of

the Housing.

Wind the cord into the Spool by turning the Spool clockwise until there is

about 14" of line on each side of the Housing.

Battery LED Lights

Check the charge percentage of your 62V Battery by pushing the Indicator

Button on the front of the Battery (Figure19). The number of Green LED

indicators will tell you the % of power left in the battery. 1-25%, 2-50%, 3-75%

and 4-100%.

If you press the Indicator Button and only the fourth LED flashes, the Battery

needs charging.

Charger indicator Lights (Figure 20)

Red LED Lit, green LED is not lit; The Charger is plugged in but the battery is

not installed (no load condition).

Green LED blinks, red LED is not lit; Battery is charging normally.

The green LED is on, red LED is not lit; Battery is fully charged.

Green LED is not lit, red LED blinks; There is a fault with the battery or charger.

Remove the Battery from the charger and wait about 30 minutes, then reinsert

the Battery into the Charger.

If the Battery does not hold its charge for very long under normal conditions or

it simply won't hold a charge, then replace it. You can purchase a replacement

Battery directly from us at www.DRpower.com.

PRO-62V STRING TRIMMER

Housing

Figure 17

Spool

Housing

Figure 18

Indicator

Button

Figure 19

Green

LED

Figure 20

Push Tab

Notches

Eyelet

Cutting line

Battery

Red

LED

Charger