- ページ 7

セキュリティシステム AMSEC ESLAuditのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AMSEC ESLAudit 15 ページ。 Access control system
AMSEC ESLAudit にも：クイック・リファレンス (4 ページ)

3. Insert the USB flash drive into the USB connector on the bottom of the controller.

4. Press the "OK" softkey located beneath the display on the right-hand side.

5. After the download is complete, remove the USB flash drive.

6. Audits can be downloaded onto a PC with the use of "ESLDat" software.

Controller Settings

Backing Up Controller Settings

If you are an ESLAudit lock administrator, it is recommended that you back up the

settings of each lock you are responsible for managing. Each time you change a setting

on the lock, you will be asked to do a backup by inserting a USB Flashdrive into the USB

connector. If you are managing multiple locations, each location should use a unique

Flashdrive to avoid over-writing data from other systems.

1. Login.

2. Press "4" (USB).

3. Press "1" (Save System).

4. Insert USB flash drive.

5. Press the "OK" softkey.

Restoring Controller Settings from a Backup File

Caution: Restoring the system configuration from the USB Flashdrive will over-write all

current system settings. If you have made any changes to the configuration or users at

the Controller without saving them, then the backup you are loading will cause those

changes to be lost. You should always back up the system after any change, and use that

Backup as the base for alterations with ESLConfig and restoration.

1. Login

2. Press "4" (USB).

3. Press "2" (Load System).

4. Insert USB flash drive.

5. Press the "OK" softkey.

6. Press the "OK" softkey.

Change PIN

1. Login

2. Press "3" (Admin).

3. Press "1" (PIN chg).

4. Enter new PIN.

5. Press the "OK" softkey.

6. Enter new PIN again.

7. Press the "OK" softkey.