- ページ 6

食器洗い機 Bosch SGE63E15UCのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Bosch SGE63E15UC 38 ページ。 24" recessed handle special application
Bosch SGE63E15UC にも：サプリメント (2 ページ), 取付説明書 (40 ページ), 取扱説明書 (40 ページ), 取扱説明書 (40 ページ), 取扱説明書 (44 ページ), パンフレット＆スペック (3 ページ), 取扱説明書 (40 ページ)

ページを印刷する

WARNING

Avoid Scalding or Electrical Shock Hazard!

Make sure the water supply and electrical supply

are shut off before installation or service.

NOTE: This dishwasher is designed to be enclosed on the

top and both sides by standard residential kitchen cabinetry.

Select a location as close to the sink as possible for easy

access to water supply and drain lines.

For proper dishwasher operation and appearance, ensure

that the enclosure is square and has the dimensions shown

in Figure 1 below.

Figure 1

NOTE: If your dishwasher opening width measures

>23

" (600mm) use the TOP or SIDE MOUNT mounting

methods.

If your dishwasher opening width measures 23

use the ALTERNATE SIDE MOUNT mounting method.

If the dishwasher is to be installed in a corner, make sure that

there is adequate clearance to open the door. See Figure

2 below.

Check clearance

between

dishwasher door

and wall

Figure 2

WARNING

Avoid Electrical Shock/Fire Hazard

Do not allow the electrical and water supply lines

Enclosure Requirements

90°

"(600mm)

Countertop

to touch.

After locating the proper place for your new dishwasher,

you will need to create any required openings to allow for

passage of the water, drain and electrical line. In order to

avoid interference with the dishwasher when sliding it into the

cabinet, place your openings within the dimensions shown

in Figure 3 below.

Required Openings:

" x 2

- To pass the included electrical supply

(120 x 60mm)

junction box through to adjacent cabinet.

Note: If the incoming electric supply, water supply and drain

connections are all in the same cabinet, the one 4

hole will be large enough for all three to pass

(120 x 60mm)

through.

4" x 2"

- To pass the included water supply line

(100 x 50mm)

toward the water supply

diameter - To pass the dishwasher drain hose

(32mm)

toward the drain connection

Before sliding the dishwasher into the cabinet, remove the

hose clip at the back of the dishwasher as shown in Figure

4. The hose clip may be used later to hold the drain hose as

shown in Figure 10.

Figure 4

In select models, remove the rubber apron on top of the

dishwasher and set aside for later use. See Figure 5.

Figure 5

Figure 3

(114mm)

(64mm)

" x 2