Bosch SGE63E15UC 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Bosch SGE63E15UC에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch SGE63E15UC 38 페이지. 24" recessed handle special application
Bosch SGE63E15UC에 대해서도 마찬가지입니다: 보충제 (2 페이지), 설치 지침 매뉴얼 (40 페이지), 사용 설명서 (40 페이지), 사용 설명서 지침 (40 페이지), 사용 설명서 (44 페이지), 브로셔 및 사양 (3 페이지), 사용 설명서 (40 페이지)

페이지 인쇄

WARNING

Avoid Scalding or Electrical Shock Hazard!

Make sure the water supply and electrical supply

are shut off before installation or service.

NOTE: This dishwasher is designed to be enclosed on the

top and both sides by standard residential kitchen cabinetry.

Select a location as close to the sink as possible for easy

access to water supply and drain lines.

For proper dishwasher operation and appearance, ensure

that the enclosure is square and has the dimensions shown

in Figure 1 below.

Figure 1

NOTE: If your dishwasher opening width measures

>23

" (600mm) use the TOP or SIDE MOUNT mounting

methods.

If your dishwasher opening width measures 23

use the ALTERNATE SIDE MOUNT mounting method.

If the dishwasher is to be installed in a corner, make sure that

there is adequate clearance to open the door. See Figure

2 below.

Check clearance

between

dishwasher door

and wall

Figure 2

WARNING

Avoid Electrical Shock/Fire Hazard

Do not allow the electrical and water supply lines

Enclosure Requirements

90°

"(600mm)

Countertop

to touch.

After locating the proper place for your new dishwasher,

you will need to create any required openings to allow for

passage of the water, drain and electrical line. In order to

avoid interference with the dishwasher when sliding it into the

cabinet, place your openings within the dimensions shown

in Figure 3 below.

Required Openings:

" x 2

- To pass the included electrical supply

(120 x 60mm)

junction box through to adjacent cabinet.

Note: If the incoming electric supply, water supply and drain

connections are all in the same cabinet, the one 4

hole will be large enough for all three to pass

(120 x 60mm)

through.

4" x 2"

- To pass the included water supply line

(100 x 50mm)

toward the water supply

diameter - To pass the dishwasher drain hose

(32mm)

toward the drain connection

Before sliding the dishwasher into the cabinet, remove the

hose clip at the back of the dishwasher as shown in Figure

4. The hose clip may be used later to hold the drain hose as

shown in Figure 10.

Figure 4

In select models, remove the rubber apron on top of the

dishwasher and set aside for later use. See Figure 5.

Figure 5

Figure 3

(114mm)

(64mm)

" x 2