- ページ 33

ページを印刷する

Determing the Problem

Problem

Washer door cannot be

opened.

Door still cannot be

opened, even after

turning the washer Off

and back on again.

Wash cycle time is

increased.

Cycle does not start -

Start/Pause flashes.

Cycle does not start -

Finish in-Time is dis-

played.

Cycle does not start -

symbol flashes.

Detergent residue

remains in the deter-

gent dispenser.

Water does not appear

to be coming into the

washer, or detergent is

not washed away.

Water cannot be seen

in the drum.

Possible cause(s)

Child lock is activated.

A power failure occured.

Cycle is running, or water level is

too high and/or too hot.

Electric power cord has become

loose or unplugged.

Program selector turned to Off

before end of cycle.

Emergency door lock released is

activated.

Child lock is activated

Door is locked for safety reasons

(high water level, temperature of

water hot, or high drum speed

(drum is turning).

Your washer utilizes sensors to

monitor certain characteristics of

the wash load. Increases in wash

cycle time could be due to:

Excess suds.

The automatic unbalanced load

detection system spins the laundry

several times to ensure even distri-

bution.

Start/Pause button not touched /

selected?

Washer door is not closed properly. Check if laundry is caught in the door. Close the door

Cycle ending time has been

selected and activated.

Child lock is activated.

Dry detergent may have been damp

or lumpy.

Excess liquid detergent may have

been added.

Use the dosing cup for liquid deter-

gent when dosing powder deter-

gent. Powder detergent may have

been damp or lumpy.

Start/Pause selected?

Water taps not turned on.

Supply hose kinked or pinched

(reduce flow).

Water supply hose strainers

clogged.

Water pressure too low.

The water level in your high effi-

ciencey front load washer is below

the visible part of the drum, this is

normal.

Solution(s)

Deactivated Child lock (touch and hold Temperature

and Finish in for approximately 3 seconds).

If a cycle is interrupted by a power failure, it will

resume when the power is restored.

Wait until the cycle ends.

Make sure the electric cord is securely plugged in.

Turn the program selector to a cycle.

~ Emergency door lock release; Page 32

Deactivated Child lock (touch and hold Temperature

and Finish in for approximately 3 seconds).

Solutions are based on the specific reason the wash

time has been extended.

Use less detergent.

Always load the washer with a mixture of large and

small wash items (easier to distribute in the drum).

Touch the Start/Pause button to start the cycle.

until a click is heard, the cycle should start.

Wash cycle will begin at proper time to complete at

the selected finish time.

Deactivate Child lock (touch and hold Temperature

and Finish in for approximately 3 seconds).

Clean and dry the detergent dispenser.

See Adding the correct amount of HE detergent to

determine proper detergent usage.

Clean and dry the detergent dispenser.

Select Start/Pause.

Turn on water taps.

Eliminate the cause.

Clean the water inlet strainers.

Eliminate the cause.

No action needed.