- ページ 34

ページを印刷する

Problem

Water has not drained

completely.

Water is coming out

from underneath the

washer.

Foam comes out of the

detergent dispenser

drawer.

The cyle status

sequence Wash flashes

in the display.

Repeated spinning.

No spin took place

(laundry is still wet).

Detergent residue on

the laundry.

System shakes or

shudders when spin

speed increases.

Possible cause(s)

Suds may be excessive (usually

due to too much detergent or non-

HE detergent being used).

Pump is blocked.

Drain hose or drain pipe is blocked. Clean drainage pipe and/or drainage hose.

Water supply hose is leaking: is not

screwed on tight at both ends, or

rubber washer not placed in hose.

Drain hose is leaking.

Too much detergent was used, or a

non-HE detergent was used; pump

was not able to pump out the

increased suds.

The Unbalanced Load Detection

system is attempting to balance the

load through repeated spins.

Load size too small.

Large items may have become

entangled in the drum and could

not be distributed by the Unbal-

anced Load Detection system; spin

cycle therefore canceled for safety

reasons.

Excessive suds: too much deter-

gent was used, or a non-HE deter-

gent was used.

No Spin was selected

Some phosphate free detergents

contain water insoluble ingredients

that may appear as light spots on

the laundry.

The washer drum suspension sys-

tem shifts during spinning as the

speed increases. This may result in

a slight shaking of the washer

during the spin speed transition.

Solution(s)

Use less detergent for future loads. Be sure to use

only high efficiency HE-detergents.

Check and clean the drain pump, water drain hose

and/or the drain pipe.

Eliminate the cause: tighten the hose (by hand at the

washer end), check for rubber washer in place.

Check the drain hose, be sure that it is on the washer

securely with the clamp in place; may need to replace

the drain hose if leaking continues.

Immediate fix: mix 1 tablespoon of fabric softener with

1/2 liter (1 pint) of water and pour this mixture into the

detergent compartment (not with waterproof fabrics).

To prevent: use less detergent for future wash loads.

To prevent: always load the washer with a mixture of

large and small wash items (easier to distribute in the

drum).

Add more laundry.

To prevent: always load the washer with a mixture of

large and small wash items (easier to distribute in the

drum).

Immediate fix: mix 1 tablespoon of fabric softener with

1/2 liter (1 pint) of water and pour this mixture into the

detergent compartment (not with waterproof fabrics).

To prevent: use less detergent for future wash loads.

Select a spin speed setting (Low, Med or High)

Brush off when laundry is dry or

execute the program Rinse.

Mix small and large laundry items together in the load

to minimize this effect. Check to be sure the washer is

level and all four feet press equally against the floor.

Transport bolts removed?

~ Remove the transport bolts; Page 13