- ページ 3

投影スクリーン Draper nocturne+ cのPDF 取付・取扱説明書をオンラインで閲覧またはダウンロードできます。Draper nocturne+ c 4 ページ。 Outdoor crank-operated projection screen
Draper nocturne+ c にも：取扱説明書 (6 ページ), 取扱説明書 (10 ページ), 説明書インストールと操作 (8 ページ)

ページを印刷する

Nocturne

Section 4 - Installing Cable Guides

Before Installing the Cable Guides, remove the Roller assembly from the Case.

(See Removing Roller Assembly section on Page 2).

1. Thread Cable Guide through dowel and then the provided hole in the endcaps

(see Figure 7).

2. Tighten the Cable Clamp. It should rest on the endcap with no slack or kinks in the

cable guide.

3. Pull the Cable Guide taught and parallel with edge of the fabric panel.

Determine the location of the Wall or Deck Mount.

4. Attach Wall or Deck Mount to surface using appropriate hardware.

5. Insert the Jackscrew end of the Cable Guide into the Wall/Deck Mount.

Tension to 8 in-lbs, so the screen will move up and down easily along the cable.

Please Note: Depending on the height of the screen, you may need to adjust where the

Cable Clamp is located on the Cable Guide.

6. Cut off the excess cable.

7. Repeat on the opposite side of the screen.

Section 9 - Component Dimensions

Headbox

(92mm)

1. Thread Cable Guide

2. Tighten Cable Clamp

3. Pull Cable Guide taught.

4. Install Wall or Deck Mount

(92mm)

NOTE: Mounting brackets attach to surface with #10 Flat Head Screw

Figure (7)

Clamp

through dowell and

then the provided hole

in the endcap.

Guide Cable

Dowel

Wall

Mount

Mounting Bracket

(102mm)

1½"

(38mm)

½"

(19mm)

page 3 of 4

" Cable

Screen

5. Attach Jackscrew of

Guide Cable to

Wall or Deck Mount

Deck

Mount

(25mm)

1¾"

(45mm)

(127mm)

(22mm)