Draper nocturne+ c Installatie- en bedieningsinstructies - Pagina 3
Blader online of download pdf Installatie- en bedieningsinstructies voor {categorie_naam} Draper nocturne+ c. Draper nocturne+ c 4 pagina's. Outdoor crank-operated projection screen
Ook voor Draper nocturne+ c: Gebruiksaanwijzing (6 pagina's), Gebruiksaanwijzing (10 pagina's), Installatie- en bedieningsinstructies (8 pagina's)
Pagina afdrukken
+
Nocturne
C
Section 4 - Installing Cable Guides
Before Installing the Cable Guides, remove the Roller assembly from the Case.
(See Removing Roller Assembly section on Page 2).
1. Thread Cable Guide through dowel and then the provided hole in the endcaps
(see Figure 7).
2. Tighten the Cable Clamp. It should rest on the endcap with no slack or kinks in the
cable guide.
3. Pull the Cable Guide taught and parallel with edge of the fabric panel.
Determine the location of the Wall or Deck Mount.
4. Attach Wall or Deck Mount to surface using appropriate hardware.
5. Insert the Jackscrew end of the Cable Guide into the Wall/Deck Mount.
Tension to 8 in-lbs, so the screen will move up and down easily along the cable.
Please Note: Depending on the height of the screen, you may need to adjust where the
Cable Clamp is located on the Cable Guide.
6. Cut off the excess cable.
7. Repeat on the opposite side of the screen.
Section 9 - Component Dimensions
Headbox
3
/
"
5
8
3
/
"
5
8
(92mm)
3
5
(92mm)
1. Thread Cable Guide
2. Tighten Cable Clamp
3. Pull Cable Guide taught.
4. Install Wall or Deck Mount
/
"
(92mm)
8
3
/
"
5
8
3
/
"
5
(92mm)
8
(92mm)
NOTE: Mounting brackets attach to surface with #10 Flat Head Screw
Figure (7)
/
/
3
3
32
32
Clamp
Clamp
through dowell and
then the provided hole
in the endcap.
Guide Cable
Dowel
Wall
OR
Mount
Mounting Bracket
4"
(102mm)
1½"
1½"
(38mm)
(38mm)
½"
½"
(19mm)
(19mm)
page 3 of 4
" Cable
" Cable
Screen
5. Attach Jackscrew of
Guide Cable to
Wall or Deck Mount
Deck
Mount
1"
(25mm)
1¾"
(45mm)
5"
(127mm)
7
/
"
(22mm)
8