- ページ 2

投影スクリーン Draper OnyxのPDF 組み立て/取り付け説明書をオンラインで閲覧またはダウンロードできます。Draper Onyx 2 ページ。 Permanently tensioned projection screen
Draper Onyx にも：組み立て/取り付け説明書 (2 ページ), 組み立て/取り付け説明書 (2 ページ)

ページを印刷する

Onyx by Draper

Surface Preparation

➀ Move frame assembly out of the way, unroll viewing surface and place

on smooth/clean surface. (Orient viewing surface so that folded side of hem

is visible.)

➁ Insert plastic tubing inside pocket formed by hem on all 4 edges of viewing

surface (see Fig. 6).

➂ Slide surface retention extrusion (rounded edge visible) along hem and

onto surface on all 4 edges of fabric (see Fig. 7).

Please Note: To make this step easier, pinch the end of the pocket closed

before sliding it into the surface retention extrusion.

Surface Retention

Extrusion

Plastic Tubing

Back of

Viewing Surface

➃ Surface retention extrusion should extend beyond edge of viewing surface

equally at both ends.

➄ Verify that all surface retention extrusions are installed with rounded edge

visible and are centered on surface material.

Surface to Frame Assembly

➀ Return frame onto clean surface, face down, and drape completed surface

assembly over completed frame profile with rounded edge of surface

retention extrusion visible.

➁ Insert any side of surface to notch #1 on corresponding side of frame

extrusion (see Fig. 8).

Surface

Retention

Extrusion

Viewing

Surface

Fabric Attachment Extrusions

➂ Insert opposite side of surface to notch #1 of frame extrusion.

➃ Repeat steps 2-3 with remaining edges of surface.

➄ Ensure surface retention extrusions are centered lengthwise in tension

slots on all 4 edges of surface.

➅ If additional tension is desired or required over time, adjust surface one

edge at a time to tension notch #2.

Please Note: It is not necessary to adjust more than one edge at a time to

increase surface tension.

Figure 6

Back of

Viewing Surface

Figure 7

Figure 8

Mounting Screen to Wall

➀ Determine height at which screen is to be mounted.

Please Note: Top edge of screen frame will be located 1.5"above mounting

bracket hole centerline when mounted to wall.

➁ Mark hole centerline so that both Z-brackets can be mounted parallel and

at equal height.

➂ Install Z-brackets so that the outermost edges are safely within the overall

length of the aluminum frame extrusion to allow for minor horizontal screen

adjustments.

➃ Position screen slightly above Z-brackets on wall (see Fig. 9).

Z-brackets and

lag screws

supplied with

screen. Installer is

responsible for

ensuring appropriate

hardware is used.

Wall

➄ Lower screen until it engages over Z-brackets. Center screen horizontally

on brackets as necessary.

Please Note: Make sure screen is installed level.

Onyx Frame—Side Detail*

*Viewing surface is approximately ¼" from wall.

Onyx (Exploded Rear View)

Page 2 of 2

Figure 9