- ページ 14
電動工具 Draper 07849のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Draper 07849 20 ページ。 10.8v rotary multi-tool kit
ページを印刷する
9.
BASIC MULTI-TOOL OPERATIONS
9.1
SWITCHING ON AND OFF – FIG.4
– Slide switch (5) into the 'I' position. This will start
the machine. Press switch to the 'O' position –
this will stop the machine.
9.2
VARIABLE SPEED CONTROL –
FIG.5
Using the variable speed dial (2) will enable you to
alter the speed of the machine:
– Select the correct speed for the work and type of
bit you are using.
9.3
FITTING ACCESSORIES – FIG.6
Note: Remove the battery from the tool before
carrying out adjustment, servicing or maintenance.
When you purchase additional accessories check the
safe working speed is compatible with the tool.
– Choose the appropriate size for the bit shank
from the five collets provided.
– If the size is not known, insert the bit into the
collet.
– The collet (19) which offers a machine fit to the
bit is the correct one to use. Do not force the bit
into a collet.
– Press spindle locking button (1) to stop the
spindle from rotating.
– Using the spanner (21), loosen the collet nut (6).
– Place the collett (19) into the spindle and loosely
replace the nut (6).
Note: Do not over tighten the collet nut (6).
9.4
FITTING ACCESSORIES USING A
MANDREL – FIG.7
– With the mandrel (20) in the chuck, remove the
screw (20.1) using the plain slot screwdriver (21)
(incorporated in the spanner handle tip).
– Leave one fibre washer on the screw, place the
cutting/grinding/polishing disc on the screw and fit
the second fibre washer, refit to the disc holder
spindle. (Do not over tighten).
9.5
HOLDING THE TOOL
For jobs such as milling or engraving where precision
is required, hold the multi-tool like a pen.
Care should be taken not to fully cover exhaust
vents. Covering the vents will cause the machine to
overheat and fail.
For heavier work like cutting or grinding hold the
multi-tool in the palm of your hand.
FIG.
4
FIG.
5
(19)
FIG.
6
(20.1)
(21)
FIG.
7
– 14 –
(5)
(2)
(1)
(6)
(20)
(6)