Draper 07849 사용자 설명서 - 페이지 14

{카테고리_이름} Draper 07849에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 07849 20 페이지. 10.8v rotary multi-tool kit

페이지 인쇄

BASIC MULTI-TOOL OPERATIONS

9.1

SWITCHING ON AND OFF – FIG.4

– Slide switch (5) into the 'I' position. This will start

the machine. Press switch to the 'O' position –

this will stop the machine.

9.2

VARIABLE SPEED CONTROL –

FIG.5

Using the variable speed dial (2) will enable you to

alter the speed of the machine:

– Select the correct speed for the work and type of

bit you are using.

9.3

FITTING ACCESSORIES – FIG.6

Note: Remove the battery from the tool before

carrying out adjustment, servicing or maintenance.

When you purchase additional accessories check the

safe working speed is compatible with the tool.

– Choose the appropriate size for the bit shank

from the five collets provided.

– If the size is not known, insert the bit into the

collet.

– The collet (19) which offers a machine fit to the

bit is the correct one to use. Do not force the bit

into a collet.

– Press spindle locking button (1) to stop the

spindle from rotating.

– Using the spanner (21), loosen the collet nut (6).

– Place the collett (19) into the spindle and loosely

replace the nut (6).

Note: Do not over tighten the collet nut (6).

9.4

FITTING ACCESSORIES USING A

MANDREL – FIG.7

– With the mandrel (20) in the chuck, remove the

screw (20.1) using the plain slot screwdriver (21)

(incorporated in the spanner handle tip).

– Leave one fibre washer on the screw, place the

cutting/grinding/polishing disc on the screw and fit

the second fibre washer, refit to the disc holder

spindle. (Do not over tighten).

9.5

HOLDING THE TOOL

For jobs such as milling or engraving where precision

is required, hold the multi-tool like a pen.

Care should be taken not to fully cover exhaust

vents. Covering the vents will cause the machine to

overheat and fail.

For heavier work like cutting or grinding hold the

multi-tool in the palm of your hand.

FIG.

(19)

FIG.

(20.1)

(21)

FIG.

– 14 –

(5)

(2)

(1)

(6)

(20)

(6)