Draper 07849 사용자 설명서 - 페이지 13
{카테고리_이름} Draper 07849에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 07849 20 페이지. 10.8v rotary multi-tool kit
페이지 인쇄
8.
PREPARING THE ROTARY MULTI-TOOL
8.1
BATTERY PACK CHARGING –
FIGS. 1 – 2
Important: Only Draper designated battery packs
and chargers can be used in conjunction with this
product. Use of any other third party battery packs/
chargers with this product is considered misuse
and will invalidate the product's warranty.
Once connected to the mains supply, recharging of
the battery can be left generally unsupervised,
requiring minimal attention. Complex circuit
construction monitors the battery condition,
adjusting the recharge current to suit. When the
recharge cycle is complete, to maintain the full
capacity, a low output current will continue as
required.
Warning! Check the condition of the charger and
battery prior to each charge. If there is any sign of
damage then do not commence charging, seek
advice from Draper Tools.
The battery pack is supplied un-charged and must
be charged before initial use.
To charge the battery pack (4), it must first be
removed from the tool.
Check the mains voltage. Make sure the voltage of
the power source is the same as the voltage
specified on the rating plate of the charger unit.
− Plug the charger adaptor mains plug into the
power source.
– Insert the battery pack (4) into the battery
charger (7).
– A full battery charge cycle will take approx. 1
hour.
– Remove the battery pack from the charger and
unplug.
8.2
BATTERY PACK CHARGE
STATUS – FIG.3
The amount of charge remaining in the battery
pack is indicated by the display (3) located on the
upper handle section.
– The display is made up of three lights; green,
orange and red, that illuminate every time the
ON/OFF switch is operated.
– The level of charge remaining determines how
many of the lights will illuminate; Red being
minimal low power, red/orange being half
power. All three lights illuminated, indicate full
charge.
FIG.
1
FIG.
2
(3)
FIG.
3
– 13 –
(4)
(4)
(7)