- ページ 14

サンダー Draper 65084のPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。Draper 65084 20 ページ。 Dual action air composite sander
Draper 65084 にも：ユーザーマニュアル (16 ページ)

ページを印刷する

8. Maintenance and Storage

8.3 Storing the Air Sander

• Disconnect the air line and remove the air line

coupling or whip hose when storing the product.

Important: Lubricate the mechanism by pouring a

few drops of air tool oil into the air line coupling

and depressing the trigger lever several times

before storage.

8.4 Troubleshooting

Problem

The sander no longer operates.

The sander operates with

reduced power.

The trigger is stiff or resists

excessively when depressed, or

does not release easily.

The spindle does not turn.

The tool will not switch off.

If the issue cannot be resolved, contact Draper Tools for support.

• Wipe the sander clean and remove any obstructions

• Ensure that the retaining clip (6) is installed beneath

• Store the product in a clean and dry location, out of

Possible Cause

The air pressure is too low.

The trigger mechanism has

malfunctioned.

The air line is obstructed.

The air pressure is low.

The rotor vane is seized.

The hydraulics mechanism requires

lubrication or is obstructed.

The rotor vane is broken.

The o-rings at the throttle valve are

broken or dislodged.

– 14 –

from the dust outlet (3) before storage.

the trigger lever (9).

reach of children.

Remedy

Check that the air line is connected

and not damaged.

Inspect and repair the trigger

mechanism as necessary. Pour a

little air tool oil into the air line

inlet and squeeze the trigger

several times.

Switch off and detach the air line.

Clean the air line and air inlet and

remove any obstructions.

Check the CFM rating of the air

compressor, set the pressure

appropriately, and check for

loose connections.

Pour a little air tool oil into the air

line inlet and squeeze the trigger

several times.

Pour a little air tool oil into the air

line inlet and squeeze the trigger

several times.

Contact Draper Tools for support.

Replace the o-ring seal or contact

Draper Tools for support.