Draper 65084 Manual de instruções original - Página 14
Procurar online ou descarregar pdf Manual de instruções original para Lixadeira Draper 65084. Draper 65084 20 páginas. Dual action air composite sander
Também para Draper 65084: Manual do utilizador (16 páginas)
Imprimir página
8. Maintenance and Storage
8.3 Storing the Air Sander
• Disconnect the air line and remove the air line
coupling or whip hose when storing the product.
Important: Lubricate the mechanism by pouring a
few drops of air tool oil into the air line coupling
and depressing the trigger lever several times
before storage.
8.4 Troubleshooting
Problem
The sander no longer operates.
The sander operates with
reduced power.
The trigger is stiff or resists
excessively when depressed, or
does not release easily.
The spindle does not turn.
The tool will not switch off.
If the issue cannot be resolved, contact Draper Tools for support.
• Wipe the sander clean and remove any obstructions
• Ensure that the retaining clip (6) is installed beneath
• Store the product in a clean and dry location, out of
Possible Cause
The air pressure is too low.
The trigger mechanism has
malfunctioned.
The air line is obstructed.
The air pressure is low.
The rotor vane is seized.
The hydraulics mechanism requires
lubrication or is obstructed.
The rotor vane is broken.
The o-rings at the throttle valve are
broken or dislodged.
– 14 –
from the dust outlet (3) before storage.
the trigger lever (9).
reach of children.
Remedy
Check that the air line is connected
and not damaged.
Inspect and repair the trigger
mechanism as necessary. Pour a
little air tool oil into the air line
inlet and squeeze the trigger
several times.
Switch off and detach the air line.
Clean the air line and air inlet and
remove any obstructions.
Check the CFM rating of the air
compressor, set the pressure
appropriately, and check for
loose connections.
Pour a little air tool oil into the air
line inlet and squeeze the trigger
several times.
Pour a little air tool oil into the air
line inlet and squeeze the trigger
several times.
Contact Draper Tools for support.
Replace the o-ring seal or contact
Draper Tools for support.
EN