- ページ 19

インバーター Advanced Energy Industries RFX 600のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Advanced Energy Industries RFX 600 20 ページ。 Advanced energy generator

FIRST TIME OPERATION

Unpacking

DO NOT APPLY POWER TO THE UNIT BEFORE FOLLOWING THIS

PROCEDURE:

Unpack and inspect your power supply carefully.

Check for

obvious physical damage.

Remove the top cover (6 phillips screws).

Inspect the

plexiglass shield for signs of physical damage and if none,

replace cover and proceed to the connection section.

Start-up Procedure

Connect output connector to ATX.

Connect input power (115 VAC or 240 VAC).

Turn on breaker at rear of unit.

Fan will turn on.

Press power push button on the front panel.

Both

displays will turn on, as well as the power LED, RF OFF

LED, and any control button that is activated.

To set output level, select regulation mode (FWDPWR, DC

BIAS, or LOAD PWR).

Press SETPOINT push button and hold

while adjusting power level.

Observe left display for

desired value.

Release button.

CAUTION!

The next step will cause RF to be present at the output

connector.

Take appropriate steps to prevent electrical

shock.

To enable output, press RF on.

The main contactor will

close and the output light will come on.

The SETPOINT

light will continue to flash until the output is

delivering its preset level.