- ページ 35

洗濯機 Bosch WLT SeriesのPDF 取扱説明書および取付説明書をオンラインで閲覧またはダウンロードできます。Bosch WLT Series 40 ページ。

ページを印刷する

Information on the display panel

Display

è lights up

è flashes

r lights up

E:18

E:23

E:32

Å lights up

: the 'Ready in' time

flashes

.the 'Ready in' time

flashes

Other displays

Cause/remedy

The temperature is too high. Wait until the temperature drops.

■

The water level is too high. It is not possible to add laundry. Close the door

■

immediately, if necessary. Press the A button to continue the program.

Laundry may be caught. Open and close the door again and press the A but-

■

ton.

If necessary, push the door closed or remove some laundry and then push it

■

closed again.

If necessary, switch the appliance off and on again; set the program and make

■

your individual settings; start the program.

Turn on the cold water tap fully,

■

Supply hose kinked/trapped,

■

The water pressure is too low. Clean the filter. ~ Page 33

■

The drain pump is blocked. Clean the drain pump. ~ Page 32

■

The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.

■

~ Page 33

There is water in the base plate, the appliance is leaking. Turn off the tap. Call the

after-sales service! ~ Page 38

flashes alternately with End at the end of the programme.

Not a fault – the unbalanced load detection system has interrupted the spin cycle

because the laundry is unevenly distributed.

Distribute small and large items of laundry evenly in the drum. Spin the laundry

again if necessary.

The childproof lock is activated – deactivate it.

Too much foam has been detected and an additional wash cycle has been acti-

vated. Add less detergent to the next washing cycle with the same load.

~ Page 28

Mains voltage is too low.

Undervoltage in the wash program.

The program duration is extended.

Switch off the appliance, wait for five seconds and then switch it on again. If the dis-

play appears again, call the after-sales service. ~ Page 38

Faults and what to do about them.