Bosch WLT Series 사용 설명서 및 설치 지침 - 페이지 35
{카테고리_이름} Bosch WLT Series에 대한 사용 설명서 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch WLT Series 40 페이지.
페이지 인쇄
Information on the display panel
Display
è lights up
è flashes
r lights up
E:18
E:23
E:32
E
Å lights up
: the 'Ready in' time
flashes
.the 'Ready in' time
flashes
Other displays
Cause/remedy
The temperature is too high. Wait until the temperature drops.
■
The water level is too high. It is not possible to add laundry. Close the door
■
immediately, if necessary. Press the A button to continue the program.
Laundry may be caught. Open and close the door again and press the A but-
■
ton.
If necessary, push the door closed or remove some laundry and then push it
■
closed again.
If necessary, switch the appliance off and on again; set the program and make
■
your individual settings; start the program.
Turn on the cold water tap fully,
■
Supply hose kinked/trapped,
■
The water pressure is too low. Clean the filter. ~ Page 33
■
The drain pump is blocked. Clean the drain pump. ~ Page 32
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
■
~ Page 33
There is water in the base plate, the appliance is leaking. Turn off the tap. Call the
after-sales service! ~ Page 38
flashes alternately with End at the end of the programme.
Not a fault – the unbalanced load detection system has interrupted the spin cycle
because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum. Spin the laundry
again if necessary.
The childproof lock is activated – deactivate it.
Too much foam has been detected and an additional wash cycle has been acti-
vated. Add less detergent to the next washing cycle with the same load.
~ Page 28
Mains voltage is too low.
Undervoltage in the wash program.
The program duration is extended.
Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call the after-sales service. ~ Page 38
Faults and what to do about them.
en
35