- ページ 7
エアコン AirStage UTY-RHKGのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。AirStage UTY-RHKG 8 ページ。 Uty-rhk series
AirStage UTY-RHKG にも： 取扱説明書 (2 ページ), 取扱説明書 (20 ページ)
ページを印刷する
(5) Fix the Indoor unit address data by pressing the "
button. (Data is transferred to the indoor unit).
PROHIBITED
•
When Indoor unit address
data is not set in the indoor
unit. (-- is displayed).
•
Set the Indoor unit address
data again as per procedures
(3)-(5) above.
Refrigerant circuit address setting
(6) When the "Address code" blinks set the Address code "02" by pressing
the "
" button or "
(7) "Address data" indicator blinks. Then set the Refrigerant circuit address
data by pressing the "
(Range of setting is 00-99.)
(8) Fix the Refrigerant circuit address data by pressing the
"
" button. (Data is transferred to the indoor unit).
PROHIBITED
•
When Refrigerant circuit
address data is not set in the
indoor unit. (-- is displayed).
•
Set the Refrigerant circuit
address data again as per
procedure (6)-(8) above.
"
GOOD
When Indoor unit address data is
set in the indoor unit properly.
" button.
Address code
" button or "
" button.
Refrigerant circuit address data
Ex. When Refrigerant circuit ad-
dress "18" is selected.
GOOD
When Refrigerant circuit
address data is set in the indoor
unit properly.
Completion of address setting mode
(9) Address setting mode is released and returns to normal display if the
"
" button, "
button are pressed for more than 5 seconds simultaneously.
* Address setting mode is released automatically if no key is pressed
for 60 seconds even the above buttons are not pressed.
(Switch to Address setting mode as per procedure (1) above.)
(10) After completing the ADDRESS SETTING, be sure to turn off the power
and turn it on again.
9. FUNCTION SETTING
This procedure changes the function settings used to control the indoor unit
according to the installation conditions.
Incorrect settings can cause the indoor unit to malfunction.
This procedure should be performed by authorized installation or service
personnel only.
Perform the "FUNCTION SETTING" according to the installation conditions
using the remote controller.
•
Refer to the indoor unit installation manual for details on the function
numbers and setting numbers.
•
Prepare for setting of indoor unit referring to installation manual of indoor
unit before start of functional setting.
Start of Function setting mode
(1) Press the "
" button, "
"
" for more than 5 seconds simultaneously. Then shift
to Function setting mode.
(2) Press the "
" button or "
the Remote controller address (Select the relevant indoor unit). Then
press "
" button.
" button and "
"
Normal mode indicator
" button and
Function setting mode initial indicator
" button and select
Remote controller address
Ex. When Remote controller
address "01" is selected.
En-6