- ページ 16
スイッチ Bdcom S2510-BのPDF ハードウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Bdcom S2510-B 19 ページ。
ページを印刷する
Chapter 4
Caution:
1)
Before opening the chassis, make sure that you have released the static you
carried and then turn off the power on-off of S2510-B. Before operating any step
in Appendix B, read the section "Safety Advice".
2)
Before performing operations beside the power supply or on the chassis, turn off
the power on-off and plug out the power cable.
4.1 Opening the Chassis
This section describes how to open the chassis of the switch, required tools and
operation methods.
Caution:
When the power cable still connects the power supply, do not touch it.
When you open the chassis of the switch, you may use the following tools: These tools
are:
Crossed screwdriver
Static armguard
Perform the following steps to open the chassis of the switch:
1)
Cut off the power of the switch;
2)
Plug off all cables that connect the ports of S2510-B;
3)
Take out the bolt from the chassis with the screwdriver;
Note:
The chassis comprises of two parts: chassis and bottom. Open the chassis by holding
two sides of the chassis towards the direction of the arrow key shown in the following
figure;
S2510-B Maintenance
Figure 4-1 Opening the chassis of S2510-B
S2510-B Hardware Installation Manual
- 14 -