- ページ 3

カー・ビデオ・システム Advanced ICE 1319-1のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Advanced ICE 1319-1 7 ページ。 Holden, chevrolet & gmc caravan/trailer camera system

Before You Begin...

The following only applies to 2017+ vehicles equipped with an OEM rear camera.

• In some compatible 2017+ vehicles, the system is equipped with an additional module called the "HMI Bypass

Module" which routes LVDS and camera images to the screen from the HMI. If equipped, the module is normally

located directly beneath the BCM (driver's side under dash).

• A quick easy way to test for the presence of the HMI Bypass Module:

h Access the OEM HMI unit (Please see Figure 7 in the FAQ section at the end of this document).

h Connect the provided NTV-HAR283 Harness in between the 12-pin plug at the HMI and the vehicle's

12-pin connector, connect RCAs together.

h Start vehicle.

h Place Vehicle into reverse gear.

h With OEM reverse image on the screen, disconnect the RCAs in the NTV-HAR283 Harness.

h If the reverse image remains on the screen with the RCA disconnected, this vehicle is equipped with the

HMI Bypass Module. This means use "Caravan/Trailer Installation Schematic #2".

h If when you disconnect the RCAs, you no longer have a reverse camera image, then please use

"Caravan/Trailer Installation Schematic #1".

Installation Process

1. Begin the process by removing the factory screen, the 1319

multimedia interface is installed there.

2. Remove the Power/Can Plug and insert the plug and play

T-Harness.

3. Remove the LVDS Video cable and insert to the LVDS In mini

USB port on the multimedia interface using the LVDS Input

Cable.

4. Connect the provided LVDS Out cable to the LVDS out Mini

USB Port on the multimedia interface and connect to the LVDS

Video Input on the back of the monitor.

Please Note: The connection to the LVDS Video Input on the screen can be tight. If not pushed in tightly the screen

will not display either factory or aftermarket picture. If the factory picture still does not display please see page FAQ

section at the end of this document for different installation location of the LVDS video Leads.

Please Note: The Power/CAN connection for the Cadillac Escalade is different. Please refer to the included NAV-TV

instructions.

Please Note: This connector (Figure 3) can be used to power additional cameras.

Click here to see a quick video

on how to perform this test

Page 3

Power/CAN

LVDS Video

FIGURE 2

FIGURE 3