- ページ 3

スピーカー Anchor VoyagerのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Anchor Voyager 7 ページ。 Portable sound system

ページを印刷する

Wireless Operation

Replacing the transmitter battery

Note: The transmitter power switch must be in the OFF position!

HANDHELD: Unscrew the battery compartment cover on

the lower end of microphone. Install a fresh 9 Volt alkaline

battery* and replace the cover.

*Duracell

MN1604 or

BODY-PACK: Press the "OPEN" end of the battery cover,

equivalent.

slide it back and lift the cover. Install a fresh 9 Volt alkaline

battery* being sure to observe proper polarity. Close the cover.

Operating the wireless microphone system

The audio signal from the built-in wireless receiver is fed to

the MIC 2/WIRELESS input. Unplug any other mic from the

MIC 2 input when using the wireless system.

Operating the wireless microphone system:

1. Set the Mic 2/Wireless volume control to minimum.

2. Turn the sound system power switch ON.

3. Slide the transmitter power switch to PWR.

MIC 2

(

WIRELESS

)

The sound system's TX ON indicator

lights to indicate wireless signal (RF)

is being transmitted and received.

4. Adjust the Mic 2/Wireless control to desired volume.

Caution: Harmful feedback may occur when walking in front of a

sound system or speaker with a wireless microphone. Always point

mic away from speakers.

Using the microphone ON/MUTE switch.

When set to the "ON" position the mic operates normally.

To prevent unwanted sounds from being picked up without

MUTE

turning the transmitter off, move switch to "MUTE" position.

(The handheld mic/transmitter comes with a protective

sleeve which fits over the power and mute switches to prevent

accidental movement during use. To install it, unscrew the

battery cover and slide the sleeve onto the microphone handle.

Replace the cover.)

(wireless model only)

TX ON

Thank you for choosing an Anchor Audio portable sound system. Our products

incorporate state-of-the-art design and the finest quality of materials and

workmanship. We're proud of our products and appreciate the confidence which

you have shown by selecting an Anchor system.

I hope you'll take a few of minutes to review this manual. We've incorporated

several unique features into our products, and your knowledge of how to use

them will enhance the performance and your enjoyment of the system.

David Jacobs, President on behalf of all Anchor employees

Quick Use Guide

Voyager is a portable sound system that's simple to set up and

operate. It runs for many hours on its built-in battery. You'll

need a microphone or other input source before you begin.

Make sure the battery is fully charged before use (see page 8).

Here's how easy it is to use:

1. Set the unit in front of your audience on the floor,

Problems?

table or on a speaker stand.

Consult the

troubleshooting

2. Plug a microphone into the Mic 1 or Mic 2 input,

section on the

or plug an audio source into the line input.

back page of

3. Set all input level controls to minimum, then turn the

this manual.

power ON. Slowly increase the level control adjacent

to the input used until desired volume is reached.

4. Adjust the tone control for desired sound quality.

To operate the wireless mic system on model PB-3000W see

"Wireless Operation" on pages 9 and 10. And for more detailed

instructions, see the "Operation" section beginning on page 6.