- ページ 4

スピーカー Anchor VoyagerのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Anchor Voyager 7 ページ。 Portable sound system

ページを印刷する

Getting Started

Inspection and inventory of your system

Check unit carefully for damage which may have occurred

during transit. Each Anchor product is carefully inspected at

the factory and packed in a special carton for safe transport.

Save the

Inventory

shipping carton

and packing

• Voyager sound system

materials. They

• RC-16 charging transformer (RC-16/220 for export)

were specially

• Speaker stand adapter

designed to

ship your unit

• Warranty and registration card

safely.

All damage claims must be made with the freight carrier.

Notify the freight carrier immediately if you observe any

damage to the shipping carton or product. Repack the unit

in the carton and await inspection by the carrier's claim agent.

Notify your dealer of the pending freight claim.

Returning your unit for service or repairs

Should your unit require service, contact your dealer or our

Customer Service Department at (310) 784-2300 to obtain a

Return Authorization (RA) number. All shipments to Anchor

must include an RA number and must be shipped prepaid.

C.O.D. shipments will be refused and returned at your cost.

Warranty registration

Please fill out the warranty card and return it with a copy of

your invoice to Anchor's Customer Service Department. This

will activate your limited two year warranty.

Wireless Operation

Setting up the wireless system

Checking the Frequency Code.

Before proceeding, you must first verify that the wireless

Now Featuring

frequency of your transmitter matches the frequency of the

WIRELESS

receiver installed in your Anchor sound system.

1. The control panel of the sound system should have

the following label:

TX ON

2. The frequency code must match the code found on

the transmitter as described below:

HANDHELD: Unscrew the battery compartment

cover on lower end of the microphone. Remove the

battery (if installed) and check code on the label.

label on handheld mic/transmitter

SHURE BROTHERS INC.

LX2 HANDHELD TRANSMITTER

FREQUENCY CODE –

176.200 MHz

BODY-PACK: Check the code on the label located

behind the belt clip.

3. If the frequency codes don't match, locate the correct

transmitter whose code matches the sound system.

About the transmitter battery gauge/indicator

Assuming a battery is installed in the transmitter, you can

estimate the remaining operating time by sliding the power

Operating times

switch to the PWR position (first turn the sound system off,

using a fresh

or set the transmitter mute switch to the MUTE position).

9 volt alkaline

Observe the color of the LED indicator(s) that light up:

battery *Duracell

MN1604 or

Battery LED Indicator

equivalent.

green

green & amber

amber

red

(wireless model only)

Frequency Code label

(Shure designates a one- or two-letter code

which corresponds to the wireless frequency

at which the component operates.)

SHURE BROTHERS INC.

TX FCC ID: DD4L11

CANADA: 616 C9398

LX1 –

176.200 MHz

label on body-pack transmitter

Operating Time

6 - 20 hours

4 - 6 hours

2 - 4 hours

< 1 hour