- ページ 3

テント Anchor 20’のPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。Anchor 20’ 4 ページ。 All purpose canopy
Anchor 20’ にも：組み立て説明書 (4 ページ)

LAYOUT AT SITE

20' x 20' canopy used as example. Spread drop cloths and unroll

canopy at exact position of desired ﬁ nished assembly. Any sharp ob-

jects which must remain on site under the canopy should be padded and

taped.

Assemble side poles and lay straight out from each pole hole in canopy.

Drive a stake 1'-0" in from the end of each pole. The stake must be

driven through the ring attached to each guy rope as shown.

Note that stiff soil conditions require the 1" stake with carabiner on some

of the tents. See chart on page 2.

RAISE SIDE POLES

Start at opposite corners.

Insert side poles into pole holes and raise so that bottom of poles

slant toward center of canopy.

Adjust guy rope.

Continue with other two corners and then sides.

RAISE CENTER POLE

Assemble three-piece center pole and insert into center pole hole.

Raise to upright position and tie off jump rope to pole.

SIDE POLE ADJUSTMENT

Tighten guy ropes and then set side poles to upright position.

Adjust pole positions and guy rope tension to properly pull out

canopy.

Protective covers are recommended for all stakes.

TAKE DOWN

Loosen all guy ropes.

Spread drop cloths.

Reverse steps 1 through 4 for disassembly.

Important:

Check guy ropes periodically for tightness and good condition.

1" Stake fits through

5/8" Stake fits

carabiner. Fasten

directly through

carabiner to ring on

ring on guy rope.

guy rope.

Side Pole

Stake

Center Pole