Anchor 20’ Assembly Instructions - Page 3
Browse online or download pdf Assembly Instructions for Tent Anchor 20’. Anchor 20’ 4 pages. All purpose canopy
Also for Anchor 20’: Assembly Instructions (4 pages)
Print Page1.
LAYOUT AT SITE
20' x 20' canopy used as example. Spread drop cloths and unroll
canopy at exact position of desired fi nished assembly. Any sharp ob-
jects which must remain on site under the canopy should be padded and
taped.
Assemble side poles and lay straight out from each pole hole in canopy.
Drive a stake 1'-0" in from the end of each pole. The stake must be
driven through the ring attached to each guy rope as shown.
Note that stiff soil conditions require the 1" stake with carabiner on some
of the tents. See chart on page 2.
2.
RAISE SIDE POLES
Start at opposite corners.
Insert side poles into pole holes and raise so that bottom of poles
slant toward center of canopy.
Adjust guy rope.
Continue with other two corners and then sides.
3.
RAISE CENTER POLE
Assemble three-piece center pole and insert into center pole hole.
Raise to upright position and tie off jump rope to pole.
4.
SIDE POLE ADJUSTMENT
Tighten guy ropes and then set side poles to upright position.
Adjust pole positions and guy rope tension to properly pull out
canopy.
Protective covers are recommended for all stakes.
5.
TAKE DOWN
Loosen all guy ropes.
Spread drop cloths.
Reverse steps 1 through 4 for disassembly.
Important:
Check guy ropes periodically for tightness and good condition.
1" Stake fits through
5/8" Stake fits
carabiner. Fasten
directly through
carabiner to ring on
ring on guy rope.
guy rope.
2"
Side Pole
2"
Stake
Center Pole
3