- ページ 2

テント Anchor Economy Tent International XP SeriesのPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。Anchor Economy Tent International XP Series 3 ページ。 Frame tent

XP Series Frame Tent Assembly Instructions, continued

4. Lay the top over the frame pulling the web loops in the corner over the steel rod to hold

the top in place.

5. Raise your ﬁrst corner and lock the upright into posi on using the provided snap bu on

in the corner weldment. Stand up leeward side (the side sheltered from the wind) ﬁrst

whenever possible and as you install each upright it is advisable to a ach your top

tensioning strap and leave in a loose se ng. It is also recommended that if there is a

wind condi on of any kind you put your anchoring system in place and a ach the guys

to the anchoring system as you erect the frame.

6. From underneath the frame go to the low side. Place the center pole pin carefully

through the opening provided at the peak of the tent and place the pulley in the center

pole base over the top cable. You can now slide the center pole up the cable un it

reaches the posi on where the cables cross. Pull down slightly on the bo om cable

locking the base in posi on. At this point install the wire lock pin through the hole

provided at the bo om of the pole base to secure the base to the cables.

800-438-3226

TF:

EM:

economytent.com