- ページ 2
スピーカーシステム Anchor Beacon BEA-8000のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Anchor Beacon BEA-8000 11 ページ。
ページを印刷する
Beacon® Sound System Owners Manual
BASIC SYSTEM OPERATION
NOTE: Fully Charge Batteries Before First Use!
1. Open Line Array (below)
2. Set all Input Levels to minimum & Tone Controls to
flat (middle) setting
3. Plug wired microphone into the MIC 1 or MIC 2 jacks
and/or any audio source into the LINE-IN jacks
4. Switch POWER to ON, Power ON LED will light
5. Slowly increase Level Controls for active Input Jacks
to desired volume
6. Adjust Tone Controls for desired sound quality
IMPORTANT: Make all connections with shielded cables to avoid
hum, buzzing or interference.
OPENING BEACON LINE ARRAY
1. Open Array latches
2. Grasp handle and remove Array from base
3. Turn Array over and place on top of base
4. Close Array latches
5. Slowly flip Array Tower up until locked
securely into place
IMPORTANT: Latches MUST be locked and grill MUST
face forward for system to work!
CLOSING BEACON LINE ARRAY
1. Turn POWER to OFF
2. Fold Array in half (apply slight pressure)
3. Open latches and remove folded Array
4. Turn Array over grasp handle and slide into base
5. Close Array latches
WIRELESS RECEIVERS
TONE CONTROLS – BASS/TREBLE
LINE IN LEVEL CONTROL
MICROPHONE LEVEL CONTROLS
LINE OUT – OUTPUT JACK
Record your presentation or connnect to
another powered sound system.
LINE IN – INPUT JACKS
The 1/8 (3.5mm) jack is used to hook
up a portable CD player, iPod, laptop
or other external audio source.
Dual RCA unbalanced inputs can
be used for daisy-chaining together
multiple Beacon speakers.
UNIVERSAL MIC – INPUT JACKS
Balanced XLR – low impedance, for balanced mic,
powers condenser-type mics.
Unbalanced 1/4" – high impedance, for unbalanced
mics, no phantom power.
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
BACK PANEL OF BEA-8000CU2
(see page 5)
Balanced 1/4"
POWER SWITCH
MADE IN USA
SIX YEAR WARRANTY
BLUETOOTH RECEIVER
(see page 7)
CD/MP3 COMBO PLAYER
(see page 4)
CHARGE STATUS LEDS
Green - Charge complete
Amber - Charge nearly complete
Red - Charging has begun
Power On LED
Green - power on
Battery Empty LED
Red - charge battery immediately
USB DC OUT - 5V 500 mA
To charge/power external device
AC POWER CORD INLET
2