- ページ 7

バッテリーチャージャー Formica IntentekのPDF テクニカルマニュアル使用とケア、保証、およびインストールマニュアルをオンラインで閲覧またはダウンロードできます。Formica Intentek 17 ページ。 Wireless charging surface

ページを印刷する

INTENTEK

WIRELESS CHARGING SURFACE

™

TECHINCAL GUIDE USE & CARE, WARRANTY, AND INSTALLATON GUIDE

Example of marked reference edge.

Reference edge also marked on

decorative side with label.

1E) INTENTEK

LAMINATE BACKER SHEET INDEXING:

™

Position backer sheet aligned to the substrate board edge. Backer

must be aligned to the substrate edge and not overhang.

1F) PROCESS OF BONDING: A heat tunnel with heated or cold nip

rollers can be used or a conventional hot or cold press. Regardless

of the process, the face sheet indexing above must be maintained as

specified.

2. PRE-PRODUCTION: ENGINEERING & CNC OPERATIONS

2A) ENGINEERING: Load cut file for the job into the CNC for

cutting. Set machine to remove entire cavity for checking depth

measurement.

2B) TEST MACHINING: It is recommended that a test piece of core

is run, measured and dry fitted to ensure proper machining and fit

before processing.

2C) IMPORTANT PARTS OF CAVITY:

a. Flange for heat sink (measured from top of flange to bottom of

cavity where contract pads are, which is 13.31mm or .524 inch)

b. Blower screws recess area

c. Power board support flange

d. Structural support of area with exception of area cut out for

contact pads

FTB-0918 | Rev 2 | 6/20

Decorative sheet of

Intentek

laminate is

™

overhanging the substrate.

2D) CAVITY PERIMETER CUT:

Substrate

Backer should be flush

with the substrate

Decorative Face Sheet

overhangs substrate.

2E) BOTTOM/UP CNC PROGRAMMING: Formica Group

understands that CNC programs differ. Formica Group will supply

CAD files that will have bottom/up measurements of the cavity. Our

recommendation is to cut cavity using a bottom/up measurement

from the vacuum table. By doing this, CNC machine will reference

and cut to the deepest measurement of cavity, which is 2.3mm

(which will cut to the very back of the Intentek

sheet). If CNC programming requires top/down measurements,

fabricator will need to adjust CNC Cut file.

2F) OPTIONAL CONFIRMATOIN OF MEASURMENTS: Prior

to fabrication, should fabricator want to confirm that laminate

measurements match the CNC Cut file, do not measure from the

decorative side where the charging icon is placed. Center point

measurements can be made from backside of laminate as shown

below.

a. Formica Group requires using a perimeter cut for the contact

pad area. MDF/Particleboard/Plywood will be removed after CNC

cut is complete. For this perimeter cut, we recommend to use

1/4" or 3/8" bit.

Formica Group Technical Guide

| 7

A. Flange

B. Screw Recess

C. Powerboard Support

D. Structural Support

decorative face

™