- ページ 12

送信機 ATI Technologies B12-69のPDF O&Mマニュアルをオンラインで閲覧またはダウンロードできます。ATI Technologies B12-69 20 ページ。 2-wire wet oxidant gas transmitter

Model B12-69 Wet Oxidant Gas Transmitter

6. Slowly screw the chamber onto the sensing element body. A small amount of electrolyte will run out

of the hole from which the fill screw was removed. Place a paper towel around the sensor to absorb

the electrolyte overflow.

compressed. Once again, do not use tools to tighten.

7. Shake excess electrolyte from the vent hole on the side of the sensor and replace the fill screw and o-

ring.

The sensing module is now ready for operation. The membrane should be stretched tightly

across the tip of the sensor. When handling the assembled sensor, do not set the sensor on its tip

or damage to the membrane will result. Severe impacts on the tip of the sensor from dropping or

other misuse may cause permanent damage to the sensor.

O & M Manual

Rev-G, 7/15

Tighten the chamber until the o-ring at the top of the chamber is

- 12 -