- ページ 3

PDA Atid AT870のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Atid AT870 16 ページ。 Rf-id bluetooth
Atid AT870 にも：クイックマニュアル (12 ページ), ユーザーマニュアル (11 ページ)

● Bluetooth Manager Reference Guide

Your AT870 can optionally be built in with the Bluetooth Manager program to communicate with wireless printer. In

the Bluetooth Stack Service, your AT870 only supports SPP (Serial Printer Profile)

To make sure your Bluetooth device, keep these following tips in your mind.

1.1 To enable Bluetooth

Bluetooth is not started by default after a clean-boot is performed. It is because of your AT870 retains the bluetooth

state when a clean-boots are performed. For example, if Bluetooth was enabled before a clean-boot, Your AT870

boots up with the Bluetooth state enabled and Bluetooth virtual COM ports registered. Reactivate the connections

manually as the system does not do them. If Bluetooth was disable before a clean boot was performed, the AT870

boots up with disabled.

To turn on Bluetooth:

1.2 Bluetooth Manager

Bluetooth Manager is a program that makes your AT870 scan SPP device and connect to a device that you want use

in its scanning range.

After connecting your AT870 to SPP device through Bluetooth Manager, the AT870 supports Virtual Com Port (COM3)

and sets up the Baud-rate as 9600 bps