- ページ 17

スピーカー Community C6のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Community C6 20 ページ。 4.5", 6.5", 8" full-range c series coaxial ceiling loudspeakers
Community C6 にも：設置および操作マニュアル (16 ページ)

ページを印刷する

Loudspeaker Tap Setting

You can use a standard #2 or #3 Phillips or a

medium slot-blade screwdriver (not the one

provided with the loudspeaker kit), or just

press thumb irmly, and twist to adjust the

power control dial on the front face of the

loudspeaker baf le. As shown in Figure 19,

you can make any of ive different settings,

although the dial has dual calibrations so at

irst glance it appears to have ten settings.

The 8-ohm position is the same on both sides

and is for a low impedance connection. On

the lower-left side of the power tap control

shown in the close-up on Figure 19 are the

power values for 100-volt connections, and

on the upper right side are the power values

for 70-volt connections.

Face-mounted, screwdriver-adjustable

loudspeaker power / voltage setting dial.

Community Commercial Design Series

Note: The letters NC mean "no-connect" but

they do not actually break a connection. DO

NOT USE this setting if you're using a 100-volt

distribution scheme as the loudspeaker may

draw excessive power; it corresponds to the

highest power that can be drawn with a 70-

volt source.

This control makes it very easy and fast to

balance an installation since there is no need

to drop the loudspeakers out of their back

cans and move wires to different terminals.

Enlarged detail of typical adjustor dial

Figure 18. Setting Loudspeaker Tap

Installation and Operation Manual

Caution: Set the tap switch initially

prior to applying audio, and only

change the switch setting while the

audio ampli ier is shut off.

Page 17