Community C6 설치 및 운영 매뉴얼 - 페이지 17
{카테고리_이름} Community C6에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Community C6 20 페이지. 4.5", 6.5", 8" full-range c series coaxial ceiling loudspeakers
Community C6에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (16 페이지)
Loudspeaker Tap Setting
You can use a standard #2 or #3 Phillips or a
medium slot-blade screwdriver (not the one
provided with the loudspeaker kit), or just
press thumb irmly, and twist to adjust the
power control dial on the front face of the
loudspeaker baf le. As shown in Figure 19,
you can make any of ive different settings,
although the dial has dual calibrations so at
irst glance it appears to have ten settings.
The 8-ohm position is the same on both sides
and is for a low impedance connection. On
the lower-left side of the power tap control
shown in the close-up on Figure 19 are the
power values for 100-volt connections, and
on the upper right side are the power values
for 70-volt connections.
Face-mounted, screwdriver-adjustable
loudspeaker power / voltage setting dial.
Community Commercial Design Series
Note: The letters NC mean "no-connect" but
they do not actually break a connection. DO
NOT USE this setting if you're using a 100-volt
distribution scheme as the loudspeaker may
draw excessive power; it corresponds to the
highest power that can be drawn with a 70-
volt source.
This control makes it very easy and fast to
balance an installation since there is no need
to drop the loudspeakers out of their back
cans and move wires to different terminals.
Enlarged detail of typical adjustor dial
Figure 18. Setting Loudspeaker Tap
Installation and Operation Manual
Caution: Set the tap switch initially
prior to applying audio, and only
change the switch setting while the
audio ampli ier is shut off.
Page 17