- ページ 19

ドライヤー Bosch Axxis WTA3510UCのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch Axxis WTA3510UC 24 ページ。 Washers
Bosch Axxis WTA3510UC にも：仕様 (8 ページ)

ページを印刷する

INSTALLATION

Step 1

Unpack the Dryer

Carefully remove the packing material from the outside

of the dryer.

Step 2

Inspect the Dryer

Thoroughly inspect the dryer, prior to installation, for

possible freight or cosmetic damage.

Step 3

Position Dryer near Installation Area

Move the dryer so that it is within four feet of the desired

position.

Note: Corrugated packing material may be used to

protect the floor. Do not use corrugated material

with staples.

Step 4

Exhaust Duct

(Model WTA 3510 only!)

The WTA 3510 must be exhausted to the outdoors.

WARNING

1. To reduce the risk of fire, this dryer MUST BE

EXHAUSTED OUTDOORS.

2. DO NOT use non-metal duct with this dryer.

3. DO NOT use duct smaller than 4 inches in diameter.

4. DO NOT use exhaust hoods with magnetic latches.

5. DO NOT exhaust the dryer into a chimney, furnace

cold air duct, attic, crawl space, or any other

ductwork used for venting.

6. DO NOT install flexible duct in an enclosed wall,

ceiling or floor.

7. DO NOT crush or kink the duct.

8. Do clean and inspect the exhaust system on

a regular basis; once a year, at a minimum.

9. The exhaust duct must end with swing out

damper(s).

Be sure to install the exhaust according to all governing

codes and ordinances. Rigid metal duct is recommended

for venting this dryer. If flexible metal duct is used, be

sure it is fully supported when the dryer is in its final

position. Excess ducting should be trimmed off to avoid

sagging or kinking of the ductwork.

The duct may be connected to the left, right or back of

the WTA 3510, electric vented dryer. If connecting to the

left or right hand side of the dryer, remove the sealing

cover from the side to be used, as shown in Figure 14.

Figure 14.

The sealing cover should then be placed over the open

vent opening at the back of the dryer, as shown in

Figure 15.