- ページ 21

ドライヤー Bosch Axxis WTA3510UCのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch Axxis WTA3510UC 24 ページ。 Washers
Bosch Axxis WTA3510UC にも：仕様 (8 ページ)

ページを印刷する

Step 6

Electrical

The Bosch dryer comes with 4-wire power supply cord

pre-installed. This cord fits a 4-wire receptacle as shown

in the upper section of Figure 11.

If your receptacle is a 3-wire receptacle, as shown in the

lower section of Figure 1, a 3-wire ''Dryer Cord'' must be

purchased locally. The 4-wire cord must then be

removed and the 3-wire cord installed in its place.

Electrical Connection, 4-Wire

For a 4-wire system, all that is necessary is to plug

the 4-wire power supply cord into the 4-wire receptacle

of the proper rating.

Note: The receptacle should be located so that the plug

and receptacle will be accessible when the dryer

is in its final installed position.

Electrical Connection, 3-Wire

If your receptacle is a 3-wire receptacle as shown below,

Figure 19, you must obtain a 3-wire dryer cord. Dryer

cord can usually be found at your local hardware supply,

electrical supply or home center. Cord should have

closed loop or upturned end wire terminating connectors.

3-wire receptacle

Typical 3-wire Dryer Cord

240V/30 amp NEMA 10-30 Type SRDT

Figure 19.

Note: If the dryer is installed in a mobile home or in

areas where local codes do not permit grounding,

only a 4-wire power supply cord shall be used.

(10-30R)

To Change Cord:

1. Make sure that the dryer is not plugged into any

power outlet.

DO NOT plug end of dryer power cord into a live

receptacle before connecting dryer power cord to

dryer terminals and closing junction/splitter box as

described below.

DO NOT reuse old power supply cord.

Power cord must be changed only by a qualified

person.

2. Remove the screw from the cover of the

junction/splitter box located at the top rear

of the dryer.

3. Remove the green ground wire from the ground

terminal.

4. Remove the red, white and black wire from the

terminal block.

5. Loosen the 2 screws in the U.L. strain relief clamp,

holding the 4-wire cable.

6. Thread the 4-wire cable out through the U.L. strain

relief clamp and throw away.

7. Thread the new 3-wire dryer cord through the U.L.

strain relief clamp.

8. Attach the power cord Ground conductor (the center

wire) to the Ground terminal. Tighten the terminal so

that it securely holds the Ground conductor.

9. Attach the two remaining power cord outer

conductors to the 2 terminals labeled L. Tighten both

screws so that the power conductors are securely

held in place. See Figure 20.

10. Tighten the screws on the U.L. strain relief so that

the power cord cannot be moved.

WARNING