- ページ 6
スピーカー Community IC6-2082/26のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Community IC6-2082/26 16 ページ。 I series
ページを印刷する
CONNECTIONS AND INSTALLATION
USE THE CORRECT WIRE OR CABLE
All I SERIES loudspeakers are fitted with captive-clamp terminal blocks on the
input panel to connect to the amplifier. Terminating the wires with a spade or
ring connector (Figure 1) is recommended for secure connections. The maximum
width of the ring or spade lug should be 0.375" (9.5mm), or less. The terminal
screws are #8 (M4). The maximum wire size that can be accommodated for bare
wire connections is 10 AWG (5.26 mm
Note: Wire insulation colors may vary depending upon region or manufacturer. Be consistent with
conductor color use throughout the system.
IMPORTANT: All electrical installation connections for loudspeaker lines are subject to all applicable
governmental building and fire codes. The selection of appropriate electrical hardware to interface with the
I SERIES loudspeaker lies solely with the installation professional. Community recommends that an
appropriately licensed engineer, electrician, or other qualified professional identify and select the appropriate
conduit, fittings, wire, etc. for the installation.
CONNECTION: LOUDSPEAKER INPUT PANEL (INDOOR MODELS)
The compact models can be ordered as Low Impedance or Autoformer "T"
versions. See below for input panels for each model type.
LOW IMPEDANCE
OPERATION
MODELS
0.86"
70V/100V
OPERATION
'T' MODELS
0.86"
Page 6
).
2
+
NC
PASSIVE
INPUT
I SERIES
IC6-1062 / 1082 / 2082
4.11"
IC6-1062T
Figure 1. Input panel wiring for I SERIES compact indoor models
4.11"
Quick Start Guide
–
+
–
Made in the USA
Revised 6/1/2016
PASSIVE
THRU
Community Light & Sound, Inc.
333 East Fifth Street, Chester, PA 19013 USA
Label# 113799
I SERIES Compact 600
Autoformer 200W
Label# 114047
0.86"
I SERIES Compact 600
Autoformer 100W
0.86"
Ring
terminal
Spade
terminal
Figure 1. Wire Connectors
IC6-1082T / 2082T
4.11"
I SERIES Compact 600
Revised
Label# 11
I SERIES C
Autoform
Label# 11
I SERIES C
Autoform