- ページ 8

スピーカー Community IC6-2082/26のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Community IC6-2082/26 16 ページ。 I series

ページを印刷する

GRILLE REMOVAL / HORN ROTATION

The horns on the IC6-1082 or IC6-2082

models can be rotated 90° by removing

the grille, rotating the horn and then

reinstalling the horn and grille. This

is suggested to maintain the stated

coverage pattern if you are mounting

the IC6-1082 horizontally (landscape)

or the IC6-2082 vertically (portrait).

Illustrations

(at

right)

IC6-1082/26.

Remove the screws holding one

Community grille retention bar to the

cabinet. Remove the bar and loosen the

grille. Then remove the other retention

bar and pull the grille off and set aside.

Keep the rubber extrusions protecting

the top and bottom edges of the grille

in place (Figures 3a, 3b).

Remove the screws holding the horn in

place (Figure 3c).

Carefully pull the horn forward, rotate

it 90° and push back into place, aligning

the screw holes (Figure 3d).

Reattach the horn (Figure 3e).

Flex the grille slightly to fit it back on the

cabinet (one side at a time). Reattach

one grille retention bar, then flex the

grille, align and attach the other side.

Fully tighten the screws only after both

sides have been secured (Figure 3f).

Note: The grille retention bars will only align with

the threaded inserts in one direction - refer to the

product view for orientation. All fasteners should

be in place and fully tightened to prevent any

undesirable noise from vibration.

Page 8

show

the

5mm x 20mm

Socket Head

Screw

Figure 3a. Remove one retention bar,

loosen that side of the grille and then

remove the other retention bar

Figure 3c. Remove the screws holding

the horn in place and set aside

Figure 3e. Reattach the horn

Grille

Retention Bar

Grille

4mm x 20mm

Socket Cap

Screws

Quick Start Guide

Figure 3b. Remove the grille and set

aside for reattachment

Figure 3d. Pull the horn forward and

rotate it 90° and realign holes

Figure 3f. Reinstall the grille one side at a

time with correct orientation of the grille

retention bars.

I SERIES Compact 600