- ページ 2

ドライヤー Bosch Programme TableのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch Programme Table 8 ページ。 Front-loading washing machine
Bosch Programme Table にも：取扱説明書 (10 ページ), 取扱説明書 (8 ページ), 取扱説明書 (8 ページ), 取扱説明書 (8 ページ), 取扱説明書 (8 ページ), 据付・取扱説明書 (32 ページ), 据付・取扱説明書 (32 ページ), 取扱説明書 (10 ページ), 取扱説明書 (10 ページ), 取扱説明書 (8 ページ), 取扱説明書 (10 ページ), 取扱説明書 (8 ページ), 取付・使用説明書 (8 ページ), 取扱説明書 (8 ページ), 取扱説明書 (8 ページ), 取扱説明書 (10 ページ), 取扱説明書 (10 ページ), 取扱説明書 (24 ページ), 取扱説明書 (8 ページ), 取扱説明書 (10 ページ), 取扱説明書 (10 ページ), 取扱説明書 (8 ページ), 取扱説明書 (8 ページ), 取扱説明書 (10 ページ), 取扱説明書 (8 ページ), 取扱説明書 (10 ページ), 取扱説明書 (8 ページ), 取扱説明書 (8 ページ), 取扱説明書 (24 ページ), 操作およびインストール手順 (29 ページ), 取扱説明書 (8 ページ), 取扱説明書 (10 ページ), 取扱説明書 (10 ページ), 取扱説明書 (8 ページ)

ページを印刷する

Safety instructions

Care

– Read the instruction manual and installation instructions and all other information enclosed with the washing

machine and act accordingly.

– Retain the documents for subsequent use.

Risk of electric shock

– Never pull the cable to disconnect the mains plug.

– Never insert/disconnect the mains plug with damp hands.

Danger to life

For worn-out appliances:

– Disconnect the mains plug.

– Sever the mains cable and discard along with the plug.

– Destroy the lock on the washing machine door. This will prevent children from

locking themselves in and risking their lives.

Danger of suffocation

– Keep packaging, film and packaging parts out of the reach of children.

Risk of poisoning

– Keep detergents and care products out of the reach of children.

Risk of explosion

– Items of laundry pretreated with cleaning agents containing solvents, e.g. stain

remover / cleaning solvent may lead to an explosion after being loaded into the

1. Pull the drawer out, press down the insert and fully remove the drawer from the housing.

washing machine.

2. To remove the insert: press the insert upwards from below with your finger.

Rinse items of laundry thoroughly by hand beforehand.

3. Clean the detergent dispenser tray and insert with water and a brush and dry it. Also remove

Risk of injury

– The washing machine door can become very hot.

– Be careful when draining hot detergent solution.

4. Attach the insert and engage (connect the cylinder to the guide pin).

5. Push in the detergent drawer.

– Do not climb onto the washing machine.

– Do not lean on the open washing machine door.

– Do not reach into the drum if it is still rotating.

– Be careful when opening the detergent drawer while the machine is in operation.

Consumption values

depending on model

Programme

Load

Electricity***

Water***

duration***

Cottons 30 °C*

7 kg

0,55 kWh

60 l

02:36 h

Cottons 40 °C*

7 kg

0,69 kWh

60 l

02:36 h

Cottons 60 °C*

7 kg

1,33 kWh

60 l

02:41 h

Cottons 90 °C

7 kg

2,00 kWh

64 l

02:48 h

Easy-Care 40 °C*

3 kg

0,55 kWh

55 l

01:37 h

Mixed Load 40 °C

3 kg

0,48 kWh

32 l

01:03 h

Delicate/Silk 30 °C

2 kg

0,21 kWh

31 l

00:41 h

1. Turn the programme selector to Off and disconnect the mains plug.

/ Wool 30 °C

2 kg

0,19 kWh

39 l

00:40 h

2. Drain the detergent solution

3. Pull the emergency release downwards with a tool and release.

* Programme setting for testing in accordance with valid standard EN60456.

Note on comparative tests: For testing the test programmes, wash the specified load using the maximum spin speed.

Annual energy

Annual water

Information on the display panel

Programme

Additional function

Load

consumption

F: 16

Cottons 40/60 °C

EcoPerfect**

7/3,5 kg

197 kWh

10560 l

F: 17

** Programme setting for testing and energy labelling in accordance with EU directive 2010/30/EU with cold water (15 ºC).

*** The values deviate from the indicated values depending on water pressure, hardness, and inlet temperature, ambient tem-

perature, type, amount and soiling of the laundry, detergent used, fluctuations in the power supply and selected additional

F: 18

functions.

F: 21

F: 23

Maintenance

– Risk of electric shock. Disconnect the mains plug.

– Risk of explosion. No solvents.

Before washing for the first time

Detergent solution pump

Do not load any laundry into the machine. Turn on the tap. Add the following to compartment II:

Turn the programme selector to Off and disconnect the mains plug.

– approx. 1 litre water

1. Open and remove the service flap.

– detergent (dosage according to the manufacturer's instructions for light soiling and the appropriate degree of water

hardness)

Set the programme selector to

Easy-Care 60 °C and select

Start/Reload. At the end of the programme, turn

the programme selector to Off.

2. For models with a drainage hose: Remove the drainage hose from

Machine housing, control panel

the retainer and pull it from the housing.Remove the container.

Remove the sealing cap, allow the detergent solution to flow out.

– Wipe with a soft, damp cloth.

Replace the sealing cap and place the drainage hose in the retainer.

– Do not use any abrasive cloths, scourers or cleaning agents (stainless steel cleaners).

– Remove detergent and cleaning agent residue immediately.

– Do not clean with a jet of water.

2* For models without a drainage hose: Carefully unscrew the pump cover

Cleaning the detergent drawer and housing...

until the detergent solution begins to flow out.When the service flap is

half full, close the pump cover and empty the service flap. Repeat the

... if it contains detergent or fabric softener residues.

above steps until all the detergent solution has completely drained out.

3. Carefully unscrew the pump cover (residual water).

4. Clean the interior, pump cover thread and pump housing (the impeller in

the detergent solution pump must rotate).

any detergent or fabric softener residues in the housing.

5. Replace the pump cover and screw it tightly.

6. Place the service flap back on and close.

Leave the detergent drawer open so that any residual water can evaporate.

To prevent unused detergent from flowing straight into the drain during the next wash: Pour

Washing drum and rubber seal

1 litre of water into compartment II and start the

Wipe the inside of the rubber seal dry with a cloth. Leave the washing machine door open so that the drum can dry out.

Drainage hose at the siphon

Rust stains - use chlorine-free cleaning agent, not steel wool.

Turn the programme selector to Off and disconnect the mains plug.

Descaling

Ensure there is no laundry in the machine

1. Loosen the hose clamp, carefully remove the drainage hose (residual water).

Descale the appliance according to the descaler manufacturer's instructions. This should not be necessary if the

2. Clean the drainage hose and siphon connecting piece.

correct dosage of detergent is used.

3. Reattach the drainage hose and secure the connection with the hose clamp.

Emergency release, e.g. in the event of a power cut

Filter in the water supply

The programme continues to run when the power has been restored. However, if the laundry has to be removed, the

Risk of electric shock

washing machine door can be opened as follows:

Do not immerse the HydroSafe safety device in water (contains an electric valve).

Risk of scalding.

The detergent solution and laundry may be hot. If possible, leave it to cool down. Do not reach

into the drum if it is still rotating. Do not open the washing machine door if water can be seen

Reduce the water pressure in the supply hose:

through the glass.

1. Turn off the tap.

2. Select any programme (apart from

page 10.

3. Choose

Start/Reload. Let the programme run for approximately 40

seconds.

Washing machine door can then be opened.

4. Turn the programme selector to Off. Disconnect the mains plug.

Clean the filter:

depending on model

1. Depending on model:

Close the washing machine door properly; laundry may be caught.

Disconnect the hose from the tap.

Clean the filter using a small brush.

Open the tap completely, supply hose kinked or trapped;

Clean the filter

page 10, Water pressure too low.

and/or for Standard and Aqua-Secure models:

Detergent solution pump blocked; Clean the detergent solution pump

page 10. Drainage hose / waste pipe

blocked; Clean the drainage hose at the siphon

page 10.

Remove the hose on the rear of the appliance,

Motor fault. Call customer services.

Remove the filter with pliers and clean.

Water in the base tub, appliance leaking. Call customer services.

2. Connect the hose and check for leaks.

– Risk of scalding.

What to do if ...

Allow the detergent solution to cool down.

– Turn off the tap.

Water is leaking out.

– Attach/replace the drainage hose correctly.

– Tighten the screw connection of the supply hose.

No water supply.

–

Start/Reload not selected?

Detergent not

– Tap not turned on?

dispensed.

– Filter blocked? Clean the filter

– Supply hose kinked or trapped?

Washing machine door

– Safety function active. Programme stopped?

cannot be opened.

–

(without final spin) selected?

– Can be opened by emergency release only?

Programme does not

–

Start/Reload or

Ready in time selected?

start.

– Washing machine door closed?

– Childproof lock active? Deactivate

Detergent solution is not

–

(without final spin) selected?

drained.

– Clean the detergent solution pump

– Clean the waste pipe and/or drainage hose.

Water not visible in the

– Not a fault - water below the visible area.

drum.

Unsatisfactory spin

– Not a fault - the unbalanced-load detection system has cancelled

result.

the spin cycle because of uneven distribution of the laundry.

Laundry wet/too damp.

Distribute small and large items of laundry evenly inside the drum.

–

Reduced Ironing selected?

– Selected speed too low?

The programme

– Not a fault – the programme sequence is optimised for the

duration changes

particular wash process. This may result in changes to the

during the wash cycle.

programme duration in the display field.

Drain programme.

Spin cycle performed

– Not a fault - unbalanced load detection system adjusts the

several times.

imbalance.

Residual water in the

– Not a fault - the action of the care product is not affected.

compartment for care

– Clean the insert if necessary

products.

Odour formation in the

– Run programme

Cottons 90 °C without laundry. Use

washing machine.

standard detergent.

Status display

– Too much detergent used? Mix 1 tablespoon of fabric softener

flashes. Foam may be

with ½ litre of water and pour into dispenser II (not for outdoor and

coming out of the

down-filled textiles!).

detergent drawer.

– Reduce the detergent dosage for the next wash cycle.

Intense noise formation,

– Are the appliance feet fixed?

vibrations and

Secure the appliance feet

"wandering" during the

– Transportation safety devices removed? Remove the

spin cycle.

transportation safety devices

Spin /

Drain).

Noises during spin and

– Clean detergent-solution pump

drain cycles.

Display panel/indicator

– Power cut?

lamps do not function

– Fuses triggered? Reset/change the fuse.

during operation.

– If the fault occurs repeatedly, call customer services.

Programme sequence

– Not a fault - unbalanced load detection system adjusts imbalance

longer than usual.

by repeatedly distributing the laundry.

– Not a fault - foam detection system active - adds an additional

rinse cycle.

Detergent residues

– Occasionally, phosphate-free detergents contain water-insoluble

on the laundry.

residues.

– Use the

Rinse cycle or brush out the laundry after washing.

If you cannot correct a fault yourself (switching on/off) or a repair is required:

– Turn the programme selector to Off and remove the mains plug from the socket.

– Turn off the water supply and call customer services

page 10.

page 4.

page 3, 4.

page 9.

page 5.

page 3, 4.

page 10.

page 5.

page 9.

Washing machine

Installation instructions.

page 10.

en Instruction manual

Installation instructions.