- ページ 7
トラクター・アクセサリー Carolina Swing Boom CutterのPDF オーナーズ／オペレーターズ・マニュアルをオンラインで閲覧またはダウンロードできます。Carolina Swing Boom Cutter 20 ページ。
ページを印刷する
Cutter Boom Controls
The joystick control can be easily
attached to the leg of the operator
using the Velcro straps provided.
engine "off" and remove the joystick
controller from your leg before exiting
the skid steer cab to avoid unwanted
machine or attachment movement
that could cause Death or Serious
Injury.
In order to swing or tilt the cutter
head, the auxiliary hydraulics to the
cutter drive must be turned on.
you may notice that the cutter speed
slows down a little while you are
activating the swing or cutter deck
tilt. When you have completed
swinging the boom or tilting the
cutter deck, the cutter will resume to
its normal rotation speed.
Engaging Cutter Drive
the First Time
initial startup with this attachment on
this machine, check the skid steer's
hydraulic oil level and add oil, if
necessary, before and after doing
steps 1- 6 below.
After starting skid steer, lift the
attachment 36" (915mm) off the
ground surface:
1.
With the skid steer engine RPMs
just above idle, engage the
auxiliary hydraulic flow to the
cutter head. Use your machine's
"Boom Swing" electric switch to
rotate cutter boom to the right.
Stop when the cutter has rotated
90°.
Carolina Attachments LLC.
Always turn the
During operation
If this is your
2.
Rotate the cutter head back to
the straight-ahead position.
3.
Rotate the "Cutter Tilt" using the
electric control switch until the
cutter hits the stop.
4.
Tilt cutter head in the opposite
direction until it hits its stop.
5.
Return cutter head to the level
position and the cutter boom to
the straightforward position.
Allow the cutter to run for 30
seconds to purge the air from the
system. Turn off the cutter drive,
allowing it to come to a complete
stop.
6.
Lower the cutter attachment to
the ground and shut off the skid
steer's engine and exit the
operator's compartment.
7.
Check the skid steers hydraulic oil
level, and add oil if necessary.
8.
Inspect the cutter hydraulic
plumbing for any noticeable leaks.
Correct these leaks before
continuing.
9.
Restart the skid steer. With the
attachment raised off the ground and
the engine throttle set just above idle,
engage the cutter drive circuit to start
cutter. Allow cutter to come up to
speed before increasing engine speed.
Starting the Cutter
engaging the cutter with bystanders
in the area could result in Death or
Serious Injury. Before engaging cutter
hydraulics, always make sure the area
is clear of bystanders.
Engage the cutter drive hydraulics with
the prime mover's engine at a low
rpm. Slowly raise the skid steer
engine's rpm to the correct and
desired cutter speed. Use the skid
steers throttle to set the speed; never
use a foot throttle when using the
cutter.
Page 7
Moving or
Swing Boom Cutter
March 2016