- ページ 8
トラクター・アクセサリー Carolina Swing Boom CutterのPDF オーナーズ／オペレーターズ・マニュアルをオンラインで閲覧またはダウンロードできます。Carolina Swing Boom Cutter 20 ページ。
ページを印刷する
creates a vibration when ramping up
speed, turn the cutter attachment to
the off position and investigate cause.
Refer today Troubleshooting section
in this manual.
Stopping the Cutter
When stopping the cutter, raise the
cutter slightly and lower the skid
steer's engine RPMs to an idle, and
allow the cutter to slow down. After
the cutter has slowed down you may
turn the auxiliary hydraulics to the
"off" position.
Getting Familiar with
the Attachment
cutter when bystanders are within
300' of your work area. Flying debris
could result in Death or Serious Injury.
operating on un-level ground
surfaces. A machine roll over could
result in Minor or Serious Injury.
Always wear your seat belt when
operating this attachment.
Before starting the skid steer engine
with this cutter attached, make sure
you are knowledgeable and
comfortable with the operation of the
brush cutter controls as outlined in the
previous and following sections of this
manual.
the cutter by allowing more than 20
GPM to the cutter head. This
attachment requires 14-20 gallons of
flow to cut efficiently.
When operating the cutter, set the skid
steer throttle at a speed that will
Carolina Attachments LLC.
If the cutter
Never operate the
Be cautious when
Do not over-speed
produce the required flow. Refer to
your skid steer manual or call your
local skid steer dealer for additional
help, if necessary. Your skid steer
dealer can measure the flow available
on your machine and recommend a
throttle setting that is compatible with
this attachment.
To begin with, learn what the cutter
head looks like in a level cutting
position when you are seated in the
skid steer. Knowing what a level cutter
head looks like will help you avoid
damage to the cutting blades by
cutting too close to the ground
surface.
Rotate the boom 90° to the right and
learn what the level position looks like
when cutting off to the side of the skid
steer. Roll out the skid steer's tilt
cylinder and notice how it affects the
cutter head.
The correct ground speed for cutting
with this attachment can be monitored
by sound and feel and depends on the
material density. If the skid steer
engine is bogging down or if the cutter
speed is turning too slow because of
too much load, the ground speed
should be decreased.
Listen and feel for any strange
vibration when working the cutter. A
bad vibration felt when cutting could
indicate a damaged cutting blade, or
material trying to be cut at too fast a
pace. Slow down the skid steers
ground speed to see if vibration stops.
If it does not, stop the cutter, turn off
the skid steer engine and investigate
cause of vibration. Refer to the
Troubleshooting section in this manual
for further instructions.
Always be aware of your surroundings.
When the cutter is swung 90°, the
operator has a much larger path to
Page 8
Swing Boom Cutter
March 2016