- ページ 3

計測機器 ANDILOG CENTORMETER EASYのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ANDILOG CENTORMETER EASY 16 ページ。 Torque analyzer v1.0

Introduction

Thank you for choosing the CENTORMETER EASY Torque analyzer manufactured by Andilog

Technologies.

This torque analyzer is the result of 25 years experience in force and torque measurements with

new electronic technologies offering a higher-performance and more reliable instrument.

To help you during the reading of this Operating Manual, please find below some definitions:

INTERNAL CHANEL: Also known and called as Channel V1 or Internal sensor. Referred to the

sensor which is connected to the board. This sensor cannot be disconnected from the unit. The

sensor may however be located inside the housing or outside therefore and connected by a wire

at the bottom of the gauge. The sensor can be measuring; force, torque linear or angular

displacement.

CALIBRATION: The CENTORMETER units are calibrated by Andilog and always delivered with a

certificate of calibration according to COFRAC standard. It is generally recommended to re-

calibrate your equipment once a year unless different internal procedure of you company

applied. Com-Ten Industries guarantee a full check up of your equipment, with software update

and also the adjustment of the calibration to ensure perfect accuracy of your force gauge.

II.

CAUTION - Unpacking: Check that it has not been damaged during transportation. If you have

any doubt, please contact us, and our service support will you guide you through simple checks

to ensure that the gauge has not been damaged.

The CENTORMETER Easy is supplied with:

 Power cord

 Certificate of calibration

 Operating manual

- 2 -

Operating manual – V1.0

CENTORMETER EASY