- ページ 11

水ポンプ ComNav 15CIのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。ComNav 15CI 11 ページ。 Reversing motor pumpset

Refill your steering system from the

highest reservoir.

Adjust the bleeding screws so that the

cylinder will be bled when the rod is

extended in the original direction.

Generally, you close the bleeding screw

or nipple closest to the now retracted

rod. Open the bleeding screw closest to

the rod which is now extended.

10. Use the Autopilot to fully extend the

cylinder rod to the other side.

11. Refill the highest reservoir.

12. Repeat steps 6 to 10 at least 10 times.

DURING THE FIRST TWO TO THREE THE WEEKS AFTER YOU HAVE INSTALLED THE

PUMP AND BLED THE STEERING SYSTEM, THERE MAY STILL BE SOME RESIDUAL AIR

SUSPENDED IN THE OIL. TO PREVENT POOR STEERING PERFORMANCE, IT IS

IMPORTANT THAT YOU CHECK YOUR STEERING SYSTEM RESERVOIR SEVERAL TIMES

AFTER THE INITIAL INSTALLATION AND TOP IT UP AS NECESSARY. SHOULD THERE BE

NO RESERVOIR IN YOUR STEERING SYSTEM, PLEASE CHECK THE LEVEL OF THE

HIGHEST HELM PUMP AND TOP IT UP AS NECESSARY. CONSULT THE STEERING

MANUFACTURER FOR DETAILS.

29010015V1.0(15CI & 25CI Pumps).doc

****

IMPORTANT

13. Close all bleeding screw or nipples.

Clean up any spills of oil and wipe

fittings clean. Remove any buckets or

equipment a short distance from the

cylinders and fittings.

14. Use the Autopilot to extend the rod fully

in one direction and then the other.

15. Check for leaks by looking for spilled

hydraulic fluid near or on fittings and

cylinders.

****