- ページ 9
水ポンプ ComNav 15CIのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。ComNav 15CI 11 ページ。 Reversing motor pumpset
ページを印刷する1.
Bleed your manual steering system
according
to
instructions. When you have completed
the bleeding, leave the equipment for
the bleeding procedure attached to your
hydraulic steering system.
2.
Fill your highest reservoir completely.
Turn the steering wheel just past the
stop to press as much oil as is possible
into the system.
3.
If
you
can,
recommended hydraulic oil and a piece
of plastic tubing to add extra capacity to
your highest reservoir.
Adding Capacity
29010015V1.0(15CI & 25CI Pumps).doc
PUMP BLEEDING INSTRUCTIONS
the
manufacturer's
use
a
bottle
of
The manufacturer of your system may
provide these items when you purchase
a bleeding kit for your system. If you
have a helper, have them watch the oil
level in the highest reservoir and refill it
when necessary.
4.
Your hydraulic cylinder rod is now fully
extended in one direction. To bleed the
Reversing Pump you will be extending
the cylinder rod in the other direction.
Open one and close the other bleeding
screw just as you did when bleeding the
manual part of your system and you
were extending the cylinder arm in this
direction. Generally, you close the
bleeding screw or nipple closest to the
rod which is now retracted. Open the
bleeding screw closest to the now
extended rod. See diagram on following
page.
5.
If possible, position yourself so that you
can see your hydraulic steering cylinder
while operating the steering controls of
the autopilot.
6.
You will be able to move the steering
cylinder rod by pressing the Red Key or
the Green Key on the Autopilot. When
you press the key, the lights will stop
blinking and the red or green light will
turn on. Extend the rod as far as it will
travel in the other direction.
7.
The Autopilot will stop driving the
Reversing Pump shortly after the rod
reaches the end of its travel.
8