- ページ 6

スイッチ Comnet CLFE IPS SeriesのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Comnet CLFE IPS Series 19 ページ。 High-power poe mid-span injector

INSTALLATION AND OPERATION MANUAL

System Configuration Window

The "System Configuration" window provides access to setting global configurations and status view of major

parameters.

Power Management Mode (PM)

» None: Power Management will not be performed by the firmware. User needs to power up the ports manually.

» Static /w Priority: Power is budgeted statically based on selected violation type.

› If violation type is "Class Based", then maximum permissible power for that class is budgeted.

› If violation type is "User Defined", then the configured user-defined limit is budgeted.

› If violation type is "None", then budgeted power is based on port mode.

› For Normal Mode the power budgeted is 16.2W

› For High Power Mode the power budgeted is based on ILIM/ICUT selected value.

· For ILIM/ICUT – 504/465 mA, the power budgeted is 22.5W

· For ILIM/ICUT – 563/545 mA, the power budgeted is 26.5W

· For ILIM/ICUT – 850/625 mA, the power budgeted is 31.6W

· For ILIM/ICUT – 850/725 mA, the power budgeted is 37.0W

» Static /wo Priority: Same as above except that port priority of the port is ignored.

» Static /wo Priority: Power is budgeted statically based on selected violation type.

› If violation type is "Class Based", then maximum permissible power for that class is budgeted.

› If violation type is "User Defined", then the configured user-defined limit is budgeted.

› If violation type is "None", then budgeted power is based on port mode.

› For Normal Mode the power budgeted is 16.2W

Tech SupporT: 1.888.678.9427

Figure 7: System Configuration Window

Power Management can be used in the following modes:

CLFE(X)IPS

INS_CLFE(X)IPS_REV–

12/15/11

PAGE 6